|
08-14-2013
|
#1 |
 Join Date: Mar 2013
Location: Roswell, GA
Posts: 234
|
Injector Housing to Head Port Match, Steel Gaskets?
While addressing an issue regarding injection housing fuel injector seals, Jerry, from Jerry's LT5 Gaskets and Parts pointed out the housing I was describing was not for my 95 ZR-1 but for an earlier model engine. After pulling the intake plenum i noticed a port miss match between the injector housing and the head. Didn't think much of at at the time but given this new information, I thought I would attach a photo that represents the issue. Some ports are a bit better but this was one of the worse cases. Please note that the housing was ported by the previous owner who decided to use a non-stock housing and intake plenum for porting and powder coating. Unfortunately he no longer has the original parts. I guess my question is, is this common, if not, what can be done to fix it or at least improve it?
__________________
1995 ZR1 #159 Ported,Corsa,4.10 Rear, Dual Disc RAM Clutch, Alum Flywheel, Haibeck Chip, ZFDoc Plates, Relocated Battery 400 rwhp 1992 ZR1 #280 Ported, Locked Secondary's, Flowmaster Exhaust, Haibeck Chip, 375rwhp 1996 Collectors LT4 (Stock) 1972 Convertible 434 Small Block 572 rwhp Last edited by KJL; 09-30-2013 at 05:22 PM. |
|
|
|
|
Threaded Mode