How to remove LCD connector from IP circuit board - ZR-1 Net Registry Forums

ghlkal · 07-07-2012

**updated** see post 6 for the answer (thanks everyone)

I'm trying to remove the Instrument Panel circuit board so I can repair the tach (high resistor value).

I carefully pulled up and removed the gauge connectors, but I'm stuck at trying to remove the connector from the LCD (it's the only thing holding the circuit board to the cluster). There are wires (not pins) under the connector, so I assume I should pull the white connector loose from the circuit board (arrow)

But, I can't get it to come loose and I don't want to apply too much pressure.

So, how do I get this connector off?

TIA,

Gary

07-07-2012	#1
ghlkal Join Date: Jan 2012 Location: Wisconsin Posts: 887	How to remove LCD connector from IP circuit board **updated** see post 6 for the answer (thanks everyone) I'm trying to remove the Instrument Panel circuit board so I can repair the tach (high resistor value). I carefully pulled up and removed the gauge connectors, but I'm stuck at trying to remove the connector from the LCD (it's the only thing holding the circuit board to the cluster). There are wires (not pins) under the connector, so I assume I should pull the white connector loose from the circuit board (arrow) But, I can't get it to come loose and I don't want to apply too much pressure. So, how do I get this connector off? TIA, Gary Last edited by ghlkal; 07-07-2012 at 11:33 PM.