PnP ZR-1 ECM - Raptor Skunk Works...

[RICKYRJ1]

Originally Posted by Tyler Townsley

Take the tune up with Corey. This motor is running no secondaries, agressive pnp, the first set of Jeal headers, one of the first sets of B&B with a xpipe and 36 in chambered exhaust pipes in lue of resonators, and full on injectors all the time, not something even pros have much expience with. Watched it with dual widebands yesterday and it is around 14.7 afrs most of the time in normal driving with one bank going slighly lean, its close but the main problem is the refusal to idle down when the clutch is put in until it comes to a stop. I think its in the iac steps as they show only 5 in the step down counts from 60 mph to 0 with the final step at 30. Hopefull I will get TunerPro set up on my non serial laptop tomorrow so I can watch what calibration cells are active. Finally got a decent *.adx file so I can link it to the actual *.bin the motor is running on. The *.xdf file is complete hack from the an ORIGINAL GM calibration document that I have had for a while. I give credit for the *.xdf hack to Tod P who had most of it done when I sent him the document. He also did the *.ads file which has been converted to *.adx to work with the most recient version of TunerPro. I ain't no pro but I been around long enough (1997) to know what works.

Tyler

PS I have one of the first MegaSquirts so know quite a bit about that too.

OK! I have no idea what he just said sad on my part. Glad there are brothers that do