|
09-21-2011
|
#31 |
 
Join Date: Jan 2009
Location: Portland Oregon metro area (Washington side)
Posts: 3,207
|
Re: Breather Mold Project
Since the original part is not an "F" shape and mine was loose FWIW I solved the loose connection at the joined point of the connector
by placing a small bolt with washers in the center-point between the two openings. It pinches in hard enough to both keep it on and eliminate leaks. A temp fix till this new part is available. 
__________________
Scott  Vett owner since 1979._It's about the car and the people |
|
|
|
|
Threaded Mode