Rear hatch weatherstrip - ZR-1 Net Registry Forums

evl_twn · 08-27-2006

I've noticed that the corners have separated, and also the vertical sections going up from the corners on both sides. The right side is worse, goes all the way up by the hinge area. I thought about trying to reseal it with some weatherstrip adhesive, but this is starting to look like it's too far gone. I've searched the forums (here and over on CF), but wanted to know if anyone has run into anything odd when replacing this seal? Any tools required, or is it just slide the old one off, clean the area, and slide the new one on? Also, where's the best place to get the weatherstrip from? I saw Mid America has the GM part in stock, and Funfest is in a couple weeks, which is good for 10% off.

Thanks,

Brian

08-27-2006	#1
evl_twn Join Date: Jul 2006 Location: Tennessee Posts: 116	Rear hatch weatherstrip I've noticed that the corners have separated, and also the vertical sections going up from the corners on both sides. The right side is worse, goes all the way up by the hinge area. I thought about trying to reseal it with some weatherstrip adhesive, but this is starting to look like it's too far gone. I've searched the forums (here and over on CF), but wanted to know if anyone has run into anything odd when replacing this seal? Any tools required, or is it just slide the old one off, clean the area, and slide the new one on? Also, where's the best place to get the weatherstrip from? I saw Mid America has the GM part in stock, and Funfest is in a couple weeks, which is good for 10% off. Thanks, Brian