Ignition module ground - ZR-1 Net Registry Forums

8upZR1 · 06-27-2006

I was looking at the schematic for the LT5 ignition module and saw that it has external and internal grounds. I realized then that the internal ground on my module has not been connected as I have removed the module from under the manifold for troubleshooting and now lay it on the windshield. I have since added an extra ground wire to the heat sink plate to simulate the internal ground, but it has had no positive effect. I was wondering if it is possible to fry the ignition module by cranking the motor without this ground attached. Anybody have a clue?

06-27-2006	#1
8upZR1 Join Date: Jun 2006 Location: Thunderbolt, Ga. Posts: 253	Ignition module ground I was looking at the schematic for the LT5 ignition module and saw that it has external and internal grounds. I realized then that the internal ground on my module has not been connected as I have removed the module from under the manifold for troubleshooting and now lay it on the windshield. I have since added an extra ground wire to the heat sink plate to simulate the internal ground, but it has had no positive effect. I was wondering if it is possible to fry the ignition module by cranking the motor without this ground attached. Anybody have a clue? __________________ IT IS THE FATE OF THE INNOCENT TO MEET WITH DEATH!!!