10-31-2010 | #16 |
Join Date: May 2007
Location: Westminster, Maryland
Posts: 3,689
|
Re: WMD 31 October 2010 - Big projects
WMD was a great success. We had a nice group of people including guys from New Jersey, Pennsylvania, Maryland and Virginia.
The transmission and Fidanza flywheel install went well. The only glitch was that we could not install the drive shaft with the C-beam bolted in. We had to disconnect the the C-beam at the transmission and move it out of the way to get the drive shaft to clear the edge of the tunnel framing. We haven't had that problem in the past. We had plenty of supervision: New flywheel installed: Initial report from David is "Thumbs Up" for the flywheel , new transmission and shifter. I replaced the plug wires and coils on my '93. No problems. I did not replace the A/C compressor that was blowing the 10 amp A/C Clutch fuse. The problem turned out to be a pinched wire going to the clutch. Check out the Techinal Section for some pictures. Scott stopped by with his Z06: A good time was had by all.
__________________
If it isn't fun, you aren't doing it right! 1990 Black ZR-1 - sold 1993 Quasar Blue ZR-1 1994 Competition Yellow ZR-1 1995 Dark Purple ZR-1 Maryland State Coordinator WAZOO Member |
|
|