I am ready!

[secondchance]

Well, getting ready for the next batch of maintenance here is a list of parts on hand:

1. Apair of AC-Delco rear bearing hubs (says Made in USA) from corvetterecycling.com - Thank you Phil!
2. Oil pan gasket from Jerry's Gasket.
3. A set of bushings for rear sawy bar - non-poly, looks factory but not sure.
4. Factory front and rear emblems - ones I have on the car was buffed over and especially the rear bottom circle was rounded.
5. Searching for front and rear seal for ZF6. Sent an e-mail to Bill Boudreau - Talking with Rich so that we can order in together.

Additional parts needed for later this year:

6. Clutch - we will have to discuss options, Rich.
7. Targa weather strips.
8. Window regulator, driver side - current one is getting a little lazy. Also, the way window leans easily when pulled front/rear seems to suggest track/wheels may be worn out.
9. Outside door/window edge trim - I figure since driver side is cracked, might as well replace when replacing the regulator.

Will it ever end???

Jim. Are your listening???
Any advise for parts or helpful tips for servicing is welcome.

Almost forgot!

Also ordered radio trim plate from Florida for $274 to make it look factory new. Pricey but I don't see the price coming down and a year from now, I may never find a new piece. So I bit the bullit on this one.
And 2 2ndary actuators since mine was installed backwards from the factory. After removal, old one goes into WAZOO parts list.