Samco Hose Question - ZR-1 Net Registry Forums

ralph92ZR1 · 01-27-2010

I replaced the original air intake duct with a Samco replacement about 18 months ago. Just took the Samco duct off and noticed the band clamp that secures the duct over the throttle body extension was rubbing against the pulley directly below the throttle body extension. The Samco duct fits up to the 2 marks on the throttle body and there is not any "wiggle" room. Any thoughts on what can be done to fix other than actually trimming the thickness of the Samco duct which is not a likely solution. I am probably missing something with the Samco install.
Thanks for your help and advice!

01-27-2010	#1
ralph92ZR1 Join Date: Dec 2005 Location: Shillington, Penna. Posts: 67	Samco Hose Question I replaced the original air intake duct with a Samco replacement about 18 months ago. Just took the Samco duct off and noticed the band clamp that secures the duct over the throttle body extension was rubbing against the pulley directly below the throttle body extension. The Samco duct fits up to the 2 marks on the throttle body and there is not any "wiggle" room. Any thoughts on what can be done to fix other than actually trimming the thickness of the Samco duct which is not a likely solution. I am probably missing something with the Samco install. Thanks for your help and advice! __________________ [FONT=Franklin Gothic Medium]Ralph E. Weise [/FONT]:) '92 ZR-1#473 Red/Red

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode