intake port molds - ZR-1 Net Registry Forums

tpepmeie · 01-20-2010

Got the port molds done. Pretty neat to see an LT5 port from the inside out. Also helped me confirm the cross-sectional areas.

here are primary and secondary head port (right), and also primary and secondary injector housings (left). Pay no attention to the lengths... I didn't get a "full pour" on a couple of them. In this pic, you can't see just how unfortunately large the bowl is behind the valve, as cast. We discussed seriously about welding that or using some epoxy to reduce the volume there, but didn't do it.

Todd

01-20-2010	#1
tpepmeie Join Date: Aug 2005 Location: Fishers, IN Posts: 815	intake port molds Got the port molds done. Pretty neat to see an LT5 port from the inside out. Also helped me confirm the cross-sectional areas. here are primary and secondary head port (right), and also primary and secondary injector housings (left). Pay no attention to the lengths... I didn't get a "full pour" on a couple of them. In this pic, you can't see just how unfortunately large the bowl is behind the valve, as cast. We discussed seriously about welding that or using some epoxy to reduce the volume there, but didn't do it. Todd Last edited by tpepmeie; 01-20-2010 at 08:43 PM. Reason: removed superfluous sentence.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode