Throttle Body - ZR-1 Net Registry Forums

A1990 · 10-13-2009

There has been some recent discussion on the factory use of DAG on our throttle bodies to seal the blades against the bores. My question is when we have our throttle bodies bored to 63mm, what happens to the DAG? Is it removed? Replaced?

Also, speaking of throttle bodies, I have seen some sell that are now 65mm. There has been a lot of talk about not even needing to bore them to 63mm on a stock displacement engine and now we have 65mm.

Just looking for your thoughts on both these topics.

10-13-2009	#1
A1990 Join Date: Dec 2003 Location: Grand Island NE Posts: 1,512	Throttle Body There has been some recent discussion on the factory use of DAG on our throttle bodies to seal the blades against the bores. My question is when we have our throttle bodies bored to 63mm, what happens to the DAG? Is it removed? Replaced? Also, speaking of throttle bodies, I have seen some sell that are now 65mm. There has been a lot of talk about not even needing to bore them to 63mm on a stock displacement engine and now we have 65mm. Just looking for your thoughts on both these topics. __________________ Dennis Fierstein 90 ZR-1 #2562 Atomic-Z ZR-1 Net Registry Chairman of the Board ZR-1 Net Registry Treasurer Last edited by A1990; 10-14-2009 at 10:33 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode