Main bearing cap bolts - ZR-1 Net Registry Forums

tpepmeie · 05-10-2009

Howdy gents,

Reading the FSM, it appears that the main cap bolts are Torque to Yield, and are recommended to be replaced after use. Is this, in fact, the case?

If so, where is the best place to get replacement bolts (2-bolt motor)? Are there any upgraded bolts or studs? I know Bill K used to sell the stud kit, but I think it required some machining of the block and loss of the alignment dowels.

Thanks in advance,

Todd

93 #411

05-10-2009	#1
tpepmeie Join Date: Aug 2005 Location: Fishers, IN Posts: 815	Main bearing cap bolts Howdy gents, Reading the FSM, it appears that the main cap bolts are Torque to Yield, and are recommended to be replaced after use. Is this, in fact, the case? If so, where is the best place to get replacement bolts (2-bolt motor)? Are there any upgraded bolts or studs? I know Bill K used to sell the stud kit, but I think it required some machining of the block and loss of the alignment dowels. Thanks in advance, Todd 93 #411

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode