What to use to seal Cam Covers... - ZR-1 Net Registry Forums

Ccmano · 04-03-2009

The manual calls for Permabond A136, which is somewhat difficult to get ahold of.
Loctite "equivalent" is 518 but if you check the spec's it is not quite the same particularly in it's sealing thinkness.
Permatex has "High Temp Anaerobic Flange Sealant" that spec's very similar to the Loctite 518, but still has much less sealing thickness than A136.
There also Permatex 1B but it's not anaerobic, it's alcohol based.
What is everyone using here? Anybody use "The Right Stuff"?

H

04-03-2009	#1
Ccmano Join Date: Jun 2006 Location: Sparks, NV Posts: 2,852	What to use to seal Cam Covers... The manual calls for Permabond A136, which is somewhat difficult to get ahold of. Loctite "equivalent" is 518 but if you check the spec's it is not quite the same particularly in it's sealing thinkness. Permatex has "High Temp Anaerobic Flange Sealant" that spec's very similar to the Loctite 518, but still has much less sealing thickness than A136. There also Permatex 1B but it's not anaerobic, it's alcohol based. What is everyone using here? Anybody use "The Right Stuff"? H __________________ 90'ZR-1 #1461 Red/Black Ported Intake, Degreed Cams, OBX Headers & Exhaust, Fidanza FW, Secondary Delete, Custom tune, C6 GS Wheels. Sold 08 C6 Z51 Crystal Red Metallic Sold Vararam Intake, Tune, Sold 05 C6 Z51 Red/Black Sold 90'ZR-1 #1723 Black/Gray Sold but not forgotten 91' Z51 L98 White Vert. My First, you always remember your first. Sold. Last edited by Ccmano; 04-03-2009 at 07:09 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode