Pulley Failure - ZR-1 Net Registry Forums

Locobob · 05-26-2019

Well I pulled the belt off and the pulley seems to spin freely by hand... although that doesn't mean it doesn't perform differently under load. The belt doesn't look terrible, its a little chewed up in a couple of spots. I need to check my notes for the belt size, I have the underdrive pulley set from SRP. I have Gates and Dayco pulleys available locally. I believe Gates is supposed to be the gold standard but with all the outsourcing going on who knows anymore. I did rebuild the tensioner a few years ago because it was chattering badly, I haven't seen any sign of it bouncing around since so I'm guessing that part of the assembly is okay.

05-26-2019	#15
Locobob Join Date: Jan 2004 Location: Portland, OR Posts: 1,057	Re: Pulley Failure Well I pulled the belt off and the pulley seems to spin freely by hand... although that doesn't mean it doesn't perform differently under load. The belt doesn't look terrible, its a little chewed up in a couple of spots. I need to check my notes for the belt size, I have the underdrive pulley set from SRP. I have Gates and Dayco pulleys available locally. I believe Gates is supposed to be the gold standard but with all the outsourcing going on who knows anymore. I did rebuild the tensioner a few years ago because it was chattering badly, I haven't seen any sign of it bouncing around since so I'm guessing that part of the assembly is okay. __________________ Robert ZR-1 Net Registry Oregon State Director 91 ZR-1 #431 Black/Black LPE 368 Last edited by Locobob; 05-26-2019 at 03:41 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode