HELP - LT5 Idle Air control connector - ZR-1 Net Registry Forums

WVZR-1 · 04-05-2018

This is a release tool that will reach a "Pull To Seat" terminal tab. The actual GM/Delphi tool was just a 'vise device' with a twist to tighten like a Dremel etc. You need to enter the rear of the shell.

Delphi vice is a 12180559-1 Understanding the length and the very small awl type point I'm sure the creative mind can sort it. Release shouldn't be an issue.

https://www.amazon.com/Rennsteig-Sup.../dp/B00A8GL7NA

If this link works it would be the GM/Delphi device.

https://www.ebay.co.uk/itm/GM-Delphi...75.c100623.m-1

04-05-2018	#6
WVZR-1 Join Date: Oct 2004 Posts: 1,890	Re: HELP - LT5 Idle Air control connector This is a release tool that will reach a "Pull To Seat" terminal tab. The actual GM/Delphi tool was just a 'vise device' with a twist to tighten like a Dremel etc. You need to enter the rear of the shell. Delphi vice is a 12180559-1 Understanding the length and the very small awl type point I'm sure the creative mind can sort it. Release shouldn't be an issue. https://www.amazon.com/Rennsteig-Sup.../dp/B00A8GL7NA If this link works it would be the GM/Delphi device. https://www.ebay.co.uk/itm/GM-Delphi...75.c100623.m-1 Last edited by WVZR-1; 04-05-2018 at 10:25 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode