Compression Test - ZR-1 Net Registry Forums

tf95ZR1 · 11-01-2015

I borrowed a Snap-on Compression Test kit from a buddy. It has
(4) different 8" long hard rubber hoses with one end threaded for the spark plug hole
and the other end an air compression fitting for the gauge.

The threaded end has a thick rubber washer, but with our deep-
sunk spark plug seats there is no way to get in there and tighten
the hose down. Is finger tight OK?

I also saw you can get rigid extentions. Is this what you guys use?
Thanks,
Ted

11-01-2015	#1
tf95ZR1 Join Date: Aug 2005 Location: Northridge, CA Posts: 1,454	Compression Test I borrowed a Snap-on Compression Test kit from a buddy. It has (4) different 8" long hard rubber hoses with one end threaded for the spark plug hole and the other end an air compression fitting for the gauge. The threaded end has a thick rubber washer, but with our deep- sunk spark plug seats there is no way to get in there and tighten the hose down. Is finger tight OK? I also saw you can get rigid extentions. Is this what you guys use? Thanks, Ted Last edited by tf95ZR1; 11-01-2015 at 01:34 AM. Reason: Wanted 2

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode