Electrical connector question - ZR-1 Net Registry Forums

secondchance · 07-06-2015

This is one of two connectors for the HVAC fan speed controller (fan resistor). Has anyone been successful in removing pins out of the plastic connector? Hold down clip is broken off and I found a replacement connector but if possible I would prefer to relocate existing pins as opposed to splicing the wires.

07-06-2015	#1
secondchance Join Date: Aug 2006 Location: McLean, VA Posts: 3,723	Electrical connector question This is one of two connectors for the HVAC fan speed controller (fan resistor). Has anyone been successful in removing pins out of the plastic connector? Hold down clip is broken off and I found a replacement connector but if possible I would prefer to relocate existing pins as opposed to splicing the wires.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode