Service Ride Control light reset - ZR-1 Net Registry Forums

Billy Mild · 06-15-2015

This is the last warning light I have to deal with on my ZR-1. A while back there were no codes. I looked at all the actuators on top of the shocks. They appear to all work when the key is turned. Currently I am getting a code for the passenger side actuator. I am using the ground out method to pull codes. I checked this actuator and the driver side up front and they both appear to move. I also made sure both knobs turn freely and they do.

I tried to ground out the pins to reset the code, but was unsuccessful. May not have the proper timing. I unplugged the battery to see if that would reset the light, and it did not. Any suggestions? Where are the actuators for the rear shocks?

06-15-2015	#1
Billy Mild Join Date: Aug 2014 Location: Kansas City, MO Posts: 838	Service Ride Control light reset This is the last warning light I have to deal with on my ZR-1. A while back there were no codes. I looked at all the actuators on top of the shocks. They appear to all work when the key is turned. Currently I am getting a code for the passenger side actuator. I am using the ground out method to pull codes. I checked this actuator and the driver side up front and they both appear to move. I also made sure both knobs turn freely and they do. I tried to ground out the pins to reset the code, but was unsuccessful. May not have the proper timing. I unplugged the battery to see if that would reset the light, and it did not. Any suggestions? Where are the actuators for the rear shocks? __________________ Looking for a ZR-1 1985 Yamaha RZ350-NOT STOCK 1971 Yamaha AT1-Middle of a restoration

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode