Two Questions that need your thoughts!!!

[Roadster]

Originally Posted by 8cam

That looks familiar. Sounds like you found the problem with a bad window motor. I had exactly the same issue last year and after testing the switch (it was fine), it was clear the motor was bad. Once I got the door apart it was easy to see why - the casing was slightly open and water had gotten inside. I sourced a complete window regulator assembly from a parted out car and just replaced the whole thing, much easier than replacing the motor. I think I still have the old one in the garage, intended to rebuild the old motor but I haven't gotten around to it.

Well Mark, tried out the adapters again today, there is one that works..... so I hooked up the new switch, the new motor, held it in my hand and guess what, the motor works...... All I have to do now is remove the regulator assembly and remove the motor. There was someone who suggested using plastic ties around the regulator when removing the motor, so I will try it. Also ordered a PDL actuator and will replace that also, since the door is all apart. The door window guide looks good as mentioned before, but will check out further and replace if necessary, since I have that part ready to go. This way I may never have to go into that door again in my lifetime.....