Couldm't get the 94 in gear......

[Roadster]

On the weekends I shift the 94 and the 82 in the garage, so it is easier to get into the 94 and go. We went out on Sunday, and I have noticed the past two times, that the trans is hard to shift when cold, but felt better as the Z warmed-up. So not thinking to much about it (yea right!!!) I go to move the Vettes on Monday to get them in their spots for the week, and I can't get the 94 into gear, any gear...... So I stayed relaxed and finally it went into 2nd gear. Since my garage floor is at a very slight slope, it was enough to move up a few feet and then let it roll back until I got it over on the other side of the garage. That was close....
So I lift the hood, move the ECM and check the Clutch cylinder and besides what's in there being very dark, the fluid was very low. So I add some fluid and pump the clutch pedal about 15 times, and with the engine off, it now is going into gear easier than before.
Did a search on the forum and learned alot about the system. Need to check for leaks, possibly change out the fluid and see if there is a leak, or just remove and send it out for a rebuild from one of the vendors mentioned in the thread that I was reading. Also doesn't seem hard to remove or install. This may be the next job for the Z......