ZR-1 Net Registry Forums  

Go Back   ZR-1 Net Registry Forums > C4 ZR-1 > C4 ZR-1 Technical Postings

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 12-01-2013   #10
XfireZ51
 
Join Date: May 2007
Location: Chicagoland, IL
Posts: 9,708
Default Re: TOP END REFINISHING

Quote:
Originally Posted by mike100 View Post
All you need to do is make sure your TPS is set to the indicated voltage at zero percent opening (about .54v if i recall). The IAC counts are probably 0 if it can't make it run slower than 1k rpm.

you either had a line pop off during reinstallation (or a mistake in tube routing), or your throttle body blade redo got messed up a little. Just seems like too much air. maybe you should double check the throttle angle and not the electrics.
Mike,

Yes I know about setting the TPS v, but that is affected by the Min Air adjustment. You need to get the throttle blade opening correct before you can set the idle TPS voltage properly. It's an iterative process.
Turn the key ON, then pull the IAC CONNECTOR. This should block the IAC port to the throttle body. Then start the motor. Does it idle, and if so at what RPM?
If it's too high, you need to close the throttle blades till you reach the desired idle speed. You actually set it a bit lower so you get some IAC control over the idle. Whenever you adjust the throttle blade, need to re-check TPS voltage and adjust if necessary so it is below the idle voltage threshold. Otherwise, ECM won't use the correct Spark Timing and you end up w an idle hunt.
__________________
[SIGPIC][/SIGPIC]Former Membership Chairman
Former ZR-1 Registry - BOD
1972 Corvette 4speed base Coupe SOLD long time ago
1984 Corvette Z-51/4+3 SOLD
1992 Corvette ZR-1 Aqua/Gray #474 SOLD
1992 Corvette ZR-1 Black Rose/Cognac #458
2014 Honda VFR Interceptor DX
XfireZ51 is online now   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:35 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2020