|
10-01-2013
|
#12 |
 Join Date: Mar 2013
Location: Roswell, GA
Posts: 234
|
Re: Steel IH Gaskets & Primary Port is 38mm
Paul-
You mention the secondaries, they do match quite well with the IH so I will be leaving them alone. The primaries are the ports that are mismatched. I guess I will match them the best I can. Jerry said to also be careful near the coolant passage. Need enough "meat" in between to get a good seal, but of course the IH is already done so.... it is what it is. The blue line in the pic below represents the size of the IH port. I am ready to go!!
__________________
1995 ZR1 #159 Ported,Corsa,4.10 Rear, Dual Disc RAM Clutch, Alum Flywheel, Haibeck Chip, ZFDoc Plates, Relocated Battery 400 rwhp 1992 ZR1 #280 Ported, Locked Secondary's, Flowmaster Exhaust, Haibeck Chip, 375rwhp 1996 Collectors LT4 (Stock) 1972 Convertible 434 Small Block 572 rwhp |
|
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode