About to start header install just wanted some input and had a few questions... - ZR-1 Net Registry Forums

5ABI VT · 08-21-2013

1/4 drive and deep socket got all but 2 bolts. rear cyl only had 1 bolt the rest had 2 I think.

cyl #1 Needed a wrench.. and a ratchet wrench worked perfectly from around the power steering hoses. The bolt fell but an extendable magnet pen picked it up after the manifold was out.

this one also couldnt fit a socket I think. used the wrench. I accidentally gave it a little turn tight before I realized

.

A little nudge and the manifold slipped right off and down. Uplugged the o2 and made sure it didnt snag on the braided line and it came right out !

Sucker is heavy !

08-21-2013	#11
5ABI VT Join Date: Jun 2013 Location: Toronto Posts: 783	Re: About to start header install just wanted some input and had a few questions... 1/4 drive and deep socket got all but 2 bolts. rear cyl only had 1 bolt the rest had 2 I think. cyl #1 Needed a wrench.. and a ratchet wrench worked perfectly from around the power steering hoses. The bolt fell but an extendable magnet pen picked it up after the manifold was out. this one also couldnt fit a socket I think. used the wrench. I accidentally gave it a little turn tight before I realized . A little nudge and the manifold slipped right off and down. Uplugged the o2 and made sure it didnt snag on the braided line and it came right out ! Sucker is heavy !

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode