IH to head; Gasket Failure - ZR-1 Net Registry Forums

Paul Workman · 04-28-2013

Make that X2 with those gaskets...

Right after Dominic had post-porting gasket issues, so did I; same maker. I switched to Jerry's gaskets and used that same Permatex 2 smeared around the coolant hole on both sides of the gasket...No more problems!

You can just see the coolant seeping into the intake runner in this photo, following porting the top end. I don't think it would hurt to leave a mm or two of metal cresting the coolant port when porting in that region. Just a thought.

P.

04-28-2013	#11
Paul Workman Join Date: Nov 2007 Location: Squires (near Ava MO in the Mark Twain N'tl Forest) - Missouri Posts: 6,493	Re: IH to head; Gasket Failure Make that X2 with those gaskets... Right after Dominic had post-porting gasket issues, so did I; same maker. I switched to Jerry's gaskets and used that same Permatex 2 smeared around the coolant hole on both sides of the gasket...No more problems! You can just see the coolant seeping into the intake runner in this photo, following porting the top end. I don't think it would hurt to leave a mm or two of metal cresting the coolant port when porting in that region. Just a thought. P. __________________ Good carz, good food, good friendz = the best of timez! 90 #1202 "FBI" top end ported & relieved Cam timing by "Pete the Greek" Sans secondaries Chip & dyno tuning by Haibeck Automotive SW headers, X-pipe, MF muffs Former Secretary, ZR-1 Net Registry

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode