Plenum pull advice - ZR-1 Net Registry Forums

mgbrv8 · 03-26-2013

Oh by the way for those that haven't rebuilt a A/C compressor I found a couple good videos while I was looking up the clutch bearing part numbers that are very helpful for anyone doing it for the first time. A quick note if you don't have good head pressure it is likely that you compressor has lost enough oil over the years that the pistons are worn out but there is still a chance that its just debris on the valve plates causing weak compression.

Video 1
http://www.youtube.com/watch?v=CD5lLC5v6PE

Video 2
http://www.youtube.com/watch?v=MangGmPZc6g

03-26-2013	#11
mgbrv8 Join Date: Jul 2009 Location: Texas Posts: 793	Re: Plenum pull advice Oh by the way for those that haven't rebuilt a A/C compressor I found a couple good videos while I was looking up the clutch bearing part numbers that are very helpful for anyone doing it for the first time. A quick note if you don't have good head pressure it is likely that you compressor has lost enough oil over the years that the pistons are worn out but there is still a chance that its just debris on the valve plates causing weak compression. Video 1 http://www.youtube.com/watch?v=CD5lLC5v6PE Video 2 http://www.youtube.com/watch?v=MangGmPZc6g

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode