Sealing ECM module access after chip swap? - ZR-1 Net Registry Forums

Schrade · 02-01-2013

Is this necessary? The gasket is still supple; should it still get additional RTV? Or a film of new dielectric grease?

Is the old chip of use? Should I keep it? Does anyone need one (seems I saw a request for spent modules on Mark H's web page)...

Thanks for the help on harness separation..............................

02-01-2013	#1
Schrade Join Date: Dec 2012 Location: NC Posts: 1,783	Sealing ECM module access after chip swap? Is this necessary? The gasket is still supple; should it still get additional RTV? Or a film of new dielectric grease? Is the old chip of use? Should I keep it? Does anyone need one (seems I saw a request for spent modules on Mark H's web page)... Thanks for the help on harness separation..............................

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode