OBX cat-back exhaust - ZR-1 Net Registry Forums

tomtom72 · 03-15-2012

Steve, I too will be using the supplied OBX clamps. The bolt & nut and the band are of a very low grade of s/s, if they are s/s at all. Try a magnet and you will see that it will stick, lightly, to the components. I tried the test on the Acuseal clamps that came with my Stainless Works headers and it just will not stick at all.

At the worst i may go to the marine supply stor and look to replace the nuts & bolts with real s/s ones....maybe.

Tom

03-15-2012	#24
tomtom72 Join Date: Dec 2004 Location: Jacksonville, FL USA Posts: 4,637	Re: OBX cat-back exhaust Steve, I too will be using the supplied OBX clamps. The bolt & nut and the band are of a very low grade of s/s, if they are s/s at all. Try a magnet and you will see that it will stick, lightly, to the components. I tried the test on the Acuseal clamps that came with my Stainless Works headers and it just will not stick at all. At the worst i may go to the marine supply stor and look to replace the nuts & bolts with real s/s ones....maybe. Tom __________________ 1990 ZR-1, Black/grey, #2233, stock. ZR-1 Net Reg Founding Member #316 & NCM member

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode