Oil in injector housing? - ZR-1 Net Registry Forums

A26B · 01-06-2011

Easy on the Mr.!

I wasn't able to get to a set of 90, 1st design injector housings to measure the washer/baffle hole diameter. However, I did measure the hole diameter in the cylinder heads for 91-95 models, at 7/32" drill. If your's are already drilled @ 1/4", i wouldn't re-do them, but i sure would not go any bigger.

If 7/32" is good for the 91~95, it should be good for the baffle washer too.

How about a photo or two of your fix in progress & the end result for "Mr" Dynomite & me?

01-06-2011	#10
A26B Join Date: Dec 2003 Location: Arcadia,OK Posts: 3,394	Re: Oil in injector housing? Easy on the Mr.! I wasn't able to get to a set of 90, 1st design injector housings to measure the washer/baffle hole diameter. However, I did measure the hole diameter in the cylinder heads for 91-95 models, at 7/32" drill. If your's are already drilled @ 1/4", i wouldn't re-do them, but i sure would not go any bigger. If 7/32" is good for the 91~95, it should be good for the baffle washer too. How about a photo or two of your fix in progress & the end result for "Mr" Dynomite & me? __________________ Jerry Downey JERRYS LT5 GASKETS & PARTS http://www.jerrysgaskets.com 1994 *ZR-1, Black/Black, Lingenfelter Aerobody, 416cu in, 3.91 gears, coil-over susp, Brembo brakes, etc. 2016 Black-Red, 3LT-Z51 Auto 8-speed. Last edited by A26B; 01-06-2011 at 05:43 PM.*

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode