DRM custom FX3 controller. Anyone remember these?

[scorp508]

Originally Posted by grahambehan

Here is what I have

Holy moly, Graham! Thanks for digging that out. Now I want to find a few, see if I can pull the code off, and compare the differences.

[tpr60]

I have one I bought many years ago, note on it says Road Atlanta race track. Never used it.

[scorp508]

Originally Posted by tpr60

I have one I bought many years ago, note on it says Road Atlanta race track. Never used it.

tpr60, i think you and phrogs should open them up and see what it says on the chip. For science!

The lid pops off relatively easy with small tabs around the perimeter, then two screws next to the connector. Once the screws are out, then pull the two larger black screw tabs away from the plastic body slightly while the main board facing down. The board will fall out enough where you can then remove it.

I love the old Compuserve address.
20241205_145002769_iOS.jpg

20241205_145117044_iOS.jpg

20241205_144958333_iOS.jpg

[rkreigh]

still have drm fx3 and set for full soft and hard rwar

good enough for 11.27 on drag radials

switched to coil overs so I don't use it

[dredgeguy]

Originally Posted by rkreigh

still have drm fx3 and set for full soft and hard rwar

good enough for 11.27 on drag radials

switched to coil overs so I don't use it

Ron, sent you a PM

[phrogs]

Originally Posted by scorp508

Feel like opening it up to see which chip is in it?

I will need to find it first haha when I do Ill post some photos.

[tpr60]

Just dug up the modified shock controler, it has a Bilstein sticker on the outside AK2100, inside chip has a pice of tape with code BB206A written in pen. Masking tape on the outside says "used Road Atlanta '94 performance modified by Bilstein". Also have the shocks that came with the contriller.