ZR-1 Net Registry Forums  

Go Back   ZR-1 Net Registry Forums > C4 ZR-1 > C4 ZR-1 General Postings

Reply
 
Thread Tools Display Modes
Old 07-19-2020   #11
ram_g
 
Join Date: Jun 2020
Location: Houston, TX
Posts: 183
Default Re: RIP LTPWS sensor; all removed - no error light

Quote:
Originally Posted by GOLDCYLON View Post
Welcome to the FORUM. I'm just telling you what happened. These are charged by a Piezo battery its possible one simply died. Usually when these go out its a violent affair and you will notice the carnage inside the tire. I go to Discount all the time but I bring in a demonstration sensor with the band when its time to change the tires. Normally the head is mounted in the center 180 degrees from the valve stem. I dont tell you this to piss you off but to simply tell the story is not at all accurate. Its entirely possible the sensor was partially coming off as the plastic can break but I doubt it looking at this picture. As to not having bands I disagree with your statement but it is hard finding replacement bands... So some folks pull em. GC
GC,

Thank you for the welcome and of course let me first acknowledge that what I don't know about the ZR-1 is vastly greater than what I do know, so I am eager to learn.

That said, I must admit that while I am not at all pissed off at your post, I am genuinely puzzled by what you are trying to say. If I interpret your post accurately, you are saying that the pictured sensor could not have broken off inside the tire (because it would have been worse destroyed) but must have separated (as pictured) during the second time that Discount Tire broke the bead on that wheel. That is entirely possible and I have no reason to disagree.

For all the facts to fit, though, that same sensor would have had to quit working between my first and second visits, and coincidentally would have been the same sensor (and only that sensor) destroyed during the second tire dismounting. And also something else would have had to occur during that week to start a tire vibration at speed, that was not evident when I first picked up the car after my first visit (with new tires).

Anything is possible, I suppose...
ram_g is offline   Reply With Quote
Old 07-19-2020   #12
DRM500RUBYZR-1
 
DRM500RUBYZR-1's Avatar
 
Join Date: Sep 2008
Location: Mullica Hill, New Jersey
Posts: 2,593
Default Re: RIP LTPWS sensor; all removed - no error light

29 years no problem.
Week after tire change; problem.
Must be a coincidence.

Welcome to the forum!
Better the sensors are out of there.
Be glad the vibration occurred at under 100 mph.

Marty
DRM500RUBYZR-1 is offline   Reply With Quote
Old 07-20-2020   #13
GOLDCYLON
 
GOLDCYLON's Avatar
 
Join Date: May 2007
Location: Peoria, AZ
Posts: 9,155
Default Re: RIP LTPWS sensor; all removed - no error light

Quote:
Originally Posted by ram_g View Post
GC,

Thank you for the welcome and of course let me first acknowledge that what I don't know about the ZR-1 is vastly greater than what I do know, so I am eager to learn.

That said, I must admit that while I am not at all pissed off at your post, I am genuinely puzzled by what you are trying to say. If I interpret your post accurately, you are saying that the pictured sensor could not have broken off inside the tire (because it would have been worse destroyed) but must have separated (as pictured) during the second time that Discount Tire broke the bead on that wheel. That is entirely possible and I have no reason to disagree.

For all the facts to fit, though, that same sensor would have had to quit working between my first and second visits, and coincidentally would have been the same sensor (and only that sensor) destroyed during the second tire dismounting. And also something else would have had to occur during that week to start a tire vibration at speed, that was not evident when I first picked up the car after my first visit (with new tires).

Anything is possible, I suppose...

Hmm so the vibration occurred after the first visit to Discount tire ?
__________________
GOLDCYLON - 91 ZR-1 #2014
GOLDCYLON - 90 ZR-1 #2794, 4L60e (Formerly Schrade's)

GOLDCYLON - 11 CTS-V


Arizona State Director




91 WHITE/BLACK #2014. 380 P&P&PCed,Ported Heads, Jeal Long tubes, Corsa Exhaust/FIKSE FM-5s /LED TLs, LED Headlights, Front Wilwood 6 piston narrowlite calipers and rear Wilwood caliper street shop mod,CNCed Coolant Pipes,TPI Cvr,Filter cover,Stainless Bolts, DRM/DOM PROM /ZFDOC mod build #102,DRLs,BMAD with stainless Debris Screen,Coplan Air Blaster, Pioneer APP Radio 4,Brey-Krause HB,Sub Bar,Fire extinguisher seat mount,DRM Coilovers,LEDs everywhere,Compass mirror (orange),V1 DIC hidden display, Homelink sun visor, Carbon Fiber top x3 and APSIS Carbon Fiber interior, APSIS CF Steering Wheel/NAPA Leather, Banski trailing arms, Guldstrand front suspension,urethane bushings from Prothane (total suspension) ZFDoc drive shaft safety loop, raptor shift light (orange),AO engineering louver front plate, Console seat cushion, 96CE seats with black custom Sheepskins, ss billet catch can,Viper remote entry/alarm,Cragar Rear Louvers,LED side louver lights, Dewitts Radiator with SPAL fans and a Woods 160 T-Stat

90 RED/BLACK #2794. 4L60e Automatic Stage V by RPM Transmission, TCI Dedicated TCM, OBX Stainless Headers, Corsa Exhaust, SAN Secondaries and Haibeck PROM, Exotic Muscle Coil overs, LED Interior Lights, LED Tail Lights, LED Headlights, 94 Sport seats with black custom Sheepskins , Cragar rear louvers, GS Front calipers, Banski Trailing arms, APSIS Carbon Fiber steering wheel, Front and Rear Baer Eradispeeds, DRLs, Guldstrand front suspension,urethane bushings from Prothane (total suspension), Dewitt's Raditor with Dual SPAL fans and a Haibeck 170 T-Stat

11 RED/GREY CTS-V
GOLDCYLON is offline   Reply With Quote
Old 07-20-2020   #14
ram_g
 
Join Date: Jun 2020
Location: Houston, TX
Posts: 183
Default Re: RIP LTPWS sensor; all removed - no error light

Quote:
Originally Posted by GOLDCYLON View Post
Hmm so the vibration occurred after the first visit to Discount tire ?
Yes, after the first visit. Not immediately, but a few days later. About the same time* as when the the Service LTPWS light came on**.

*Noticed the vibration a day or two after the light came on, but probably because I didn't drive it fast that day.

**No Low Tire Pressure light ever came on. Only the Service LTPWS. Ran the codes using Dynomite's ALDL code reader (basically advanced paper clip method). Code flashed 24, indicating right rear tire.

After the second visit, involving removal of all sensors and re-mounting/re-balancing, there is no light and no vibration.
ram_g is offline   Reply With Quote
Old 07-21-2020   #15
WARP TEN
 
WARP TEN's Avatar
 
Join Date: Apr 2007
Location: Lake Bluff, IL
Posts: 2,096
Default Re: RIP LTPWS sensor; all removed - no error light

Quote:
Originally Posted by DRM500RUBYZR-1 View Post
29 years no problem.
Week after tire change; problem.
Must be a coincidence.

Welcome to the forum!
Better the sensors are out of there.
Be glad the vibration occurred at under 100 mph.

Marty
Coincidence indeed. In the late '90s I got some tires at Sears for my '93. I talked to them about the tire sensors and gave them copies of the factory shop manual pictures of them and the instructions on how to change a tire with them. No help at all. They promised they had a tech experienced with them. When they called they said they had indeed broken one. But they stepped up to the plate, took responsibility for it, got me a new sensor and in the end it all worked out fine. Except for Sears because they claimed that the new sensor cost them $300. Oh well. Couldn't have happened to nicer guys...--Bob
__________________
2016 Long Beach Red Z06 #10281 "POPS Z"
1995 Polo Green #409 "WARP TEN"--Haibeck 350/510 package, 4.10s, Hurst, Stock Exhaust with QTP Cutouts
--Sold but still running strong
1993 Quasar Blue #161 "HIL KING"
--Sold but still running strong, now with more than 120,000 miles
1967 Marlboro Maroon/Saddle Corvette Coupe 300 hp/4-spd
--Sold a long time ago
ZR-1 Net Registry Founding Member #95
NCM Lifetime Member
Favorite Quote--Attributed to Mickey Thompson:
"Too Much Horsepower is Almost Enough"
WARP TEN is offline   Reply With Quote
Old 07-21-2020   #16
Black Red '90
 
Join Date: May 2018
Location: Virginia
Posts: 79
Default Re: RIP LTPWS sensor; all removed - no error light

I just dropped my '90 off at a shop yesterday to do an alignment after installing rear lowing bolts. One other issue I asked them to look at was a rattle I hear from inside the RF tire. No warning lights, and the tires are 3 years old, so I assumed the sensor may be loose. If the sensor or mounting strap is damage, can I remove just 1 without triggering a warning light or will all 4 need to be removed at the same time?


Thanks
Black Red '90 is offline   Reply With Quote
Old 07-21-2020   #17
Corvette95
 
Corvette95's Avatar
 
Join Date: Jan 2006
Location: Decatur, AL
Posts: 1,119
Default Re: RIP LTPWS sensor; all removed - no error light

I would be interested in a "to be honest" cheap deal for buying the sensor take off's and bands. Early model.
__________________
Corvette95 Registry and Forum (*************)
1989 C4 Conv Wht/Gry Auto Hardtop Top Flight SOLD
1995 C4 Coupe Purple/Blk 6 Speed
1989 C4 Conv Wht/Red Auto SOLD
1996 C4 Conv Black/Tan Auto SOLD
1994 C4 Coupe Wht/Blk SOLD
1995 C4 ZR-1 White/Gry #278 Dual Dunn Head SOLD
1986 C4 Coupe Black/Red 4+3 SOLD
1990 C4 ZR-1 Red/Red #0454
Corvette95 is offline   Reply With Quote
Old 07-21-2020   #18
ram_g
 
Join Date: Jun 2020
Location: Houston, TX
Posts: 183
Default Re: RIP LTPWS sensor; all removed - no error light

Corvette95, I just sent you a PM.
ram_g is offline   Reply With Quote
Old 07-21-2020   #19
ram_g
 
Join Date: Jun 2020
Location: Houston, TX
Posts: 183
Default Re: RIP LTPWS sensor; all removed - no error light

Quote:
Originally Posted by Black Red '90 View Post
I just dropped my '90 off at a shop yesterday to do an alignment after installing rear lowing bolts. One other issue I asked them to look at was a rattle I hear from inside the RF tire. No warning lights, and the tires are 3 years old, so I assumed the sensor may be loose. If the sensor or mounting strap is damage, can I remove just 1 without triggering a warning light or will all 4 need to be removed at the same time?


Thanks
Pretty sure all will need to be removed.
ram_g is offline   Reply With Quote
Old 07-24-2020   #20
ram_g
 
Join Date: Jun 2020
Location: Houston, TX
Posts: 183
Default Re: RIP LTPWS sensor; all removed - no error light

To add a postscript to this episode, today I purchased a set of tires (from that same Discount Tire store) for my wife's Audi SUV and they took $100 off the tab to "make right" the damage to the Corvette sensor. This was the manager's own initiative, I didn't ask for that (he actually edited the online sale I had agreed to and lowered the final price). Sure, they should not have damaged it in the first place, but I'm fine with the way this has ended.
ram_g is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:17 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2020