ZR-1 Net Registry Forums  

Go Back   ZR-1 Net Registry Forums > C4 ZR-1 > C4 ZR-1 Technical Postings

Reply
 
Thread Tools Display Modes
Old 10-02-2019   #21
frantinoro
 
Join Date: Dec 2018
Location: Long Beach, CA
Posts: 73
Default Re: 1990 ZR-1 Issues

So, I took off the air setup, and noticed one seemed to leak slightly when sucking, and had a faint taste of gas. Can I just remove the diverter and connect the two together, or do I need to block them individually to delete the air setup?
frantinoro is offline   Reply With Quote
Old 10-02-2019   #22
XfireZ51
 
Join Date: May 2007
Location: Chicagoland, IL
Posts: 9,708
Default Re: 1990 ZR-1 Issues

Quote:
Originally Posted by frantinoro View Post
So, I took off the air setup, and noticed one seemed to leak slightly when sucking, and had a faint taste of gas. Can I just remove the diverter and connect the two together, or do I need to block them individually to delete the air setup?
If u disable the A.I.R., u also need to tell the ECM u r doing that. So a minor change in the calibration is called for.
__________________
[SIGPIC][/SIGPIC]Former Membership Chairman
Former ZR-1 Registry - BOD
1972 Corvette 4speed base Coupe SOLD long time ago
1984 Corvette Z-51/4+3 SOLD
1992 Corvette ZR-1 Aqua/Gray #474 SOLD
1992 Corvette ZR-1 Black Rose/Cognac #458
2014 Honda VFR Interceptor DX
XfireZ51 is offline   Reply With Quote
Old 10-02-2019   #23
frantinoro
 
Join Date: Dec 2018
Location: Long Beach, CA
Posts: 73
Default Re: 1990 ZR-1 Issues

I was told that this wouldn't affect anything. Either way, I removed the diverter and connected the two together, and it honestly made the right bank more lean, or maybe I'm crazy. I'm open on what to test next. I noticed the cross counts for the left bank were like 10-15, vs the right bank was 0-2.
frantinoro is offline   Reply With Quote
Old 10-02-2019   #24
richarde
 
Join Date: Sep 2012
Location: United Kingdom
Posts: 68
Default Re: 1990 ZR-1 Issues

You said originally that 'I got my zr-1 and it never ran right, but after sitting for a few months it's a lot worse'.
I guess that you purchased it earlier this year. Did you get any history with the car that could point to a resolution? Could it be a mechanical issue that is 'tricking' the sensors?
richarde is offline   Reply With Quote
Old 10-02-2019   #25
frantinoro
 
Join Date: Dec 2018
Location: Long Beach, CA
Posts: 73
Default Re: 1990 ZR-1 Issues

I did not get any history with the car no. I did notice that the INT creeps up ONLY at idle. I changed what I thought was my leaky check valve with a new one and no fix. Although I JUST found out both my resonators are cracked.
frantinoro is offline   Reply With Quote
Old 10-02-2019   #26
A26B
 
A26B's Avatar
 
Join Date: Dec 2003
Location: Arcadia,OK
Posts: 3,394
Default Re: 1990 ZR-1 Issues

Quote:
Originally Posted by frantinoro View Post
I did not get any history with the car no. I did notice that the INT creeps up ONLY at idle. I changed what I thought was my leaky check valve with a new one and no fix. Although I JUST found out both my resonators are cracked.
BOTH??? resonsators Only one resonator (in the middle) & 2 mufflers @ rear. Are you perhaps referring to the catalytic converters, welded into the exhaust manifolds?
__________________
Jerry Downey
JERRYS LT5 GASKETS & PARTS
http://www.jerrysgaskets.com
1994 ZR-1, Black/Black, Lingenfelter Aerobody, 416cu in, 3.91 gears, coil-over susp, Brembo brakes, etc.
2016 Black-Red, 3LT-Z51 Auto 8-speed.
A26B is offline   Reply With Quote
Old 10-02-2019   #27
frantinoro
 
Join Date: Dec 2018
Location: Long Beach, CA
Posts: 73
Default Re: 1990 ZR-1 Issues

Hi, yes both. I have a Corsa cat back. I doubt that would cause my issues though. What should I test next? I'm really stumped.
frantinoro is offline   Reply With Quote
Old 10-02-2019   #28
XfireZ51
 
Join Date: May 2007
Location: Chicagoland, IL
Posts: 9,708
Default Re: 1990 ZR-1 Issues

If resonators are leaking they could suck fresh sir into the exhaust which could impact the operation of the O2s.
__________________
[SIGPIC][/SIGPIC]Former Membership Chairman
Former ZR-1 Registry - BOD
1972 Corvette 4speed base Coupe SOLD long time ago
1984 Corvette Z-51/4+3 SOLD
1992 Corvette ZR-1 Aqua/Gray #474 SOLD
1992 Corvette ZR-1 Black Rose/Cognac #458
2014 Honda VFR Interceptor DX
XfireZ51 is offline   Reply With Quote
Old 10-02-2019   #29
frantinoro
 
Join Date: Dec 2018
Location: Long Beach, CA
Posts: 73
Default Re: 1990 ZR-1 Issues

Even though they're like 3 feet downstream?
frantinoro is offline   Reply With Quote
Old 10-02-2019   #30
XfireZ51
 
Join Date: May 2007
Location: Chicagoland, IL
Posts: 9,708
Default Re: 1990 ZR-1 Issues

Quote:
Originally Posted by frantinoro View Post
Even though they're like 3 feet downstream?
Its happened to me with a leak at the muffler. Idle and Decel are two pointa where engine vacuum is at its highest. It can pull fresh air past the O2s creating a “false lean” condition. That in turn will cause the ECM to richen the AFR.
__________________
[SIGPIC][/SIGPIC]Former Membership Chairman
Former ZR-1 Registry - BOD
1972 Corvette 4speed base Coupe SOLD long time ago
1984 Corvette Z-51/4+3 SOLD
1992 Corvette ZR-1 Aqua/Gray #474 SOLD
1992 Corvette ZR-1 Black Rose/Cognac #458
2014 Honda VFR Interceptor DX
XfireZ51 is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 06:31 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2020