Console cup holder

[GOLDCYLON]

Originally Posted by geezer

With respect Sir...… based on my 1 owner 1990 they Did Not have a cup insert. My '90 was never out of my sight from the moment it rolled off the Carrier Truck at the dealer. Just a little anal about the ZR1 arrival ;;ya think!!

Nobody doubts you didn't get one. However these are soft goods and dealer prep items. Just like the console book, floor mats, demo cassettes and yes the rubber console cup. It was up to each dealer to make sure these went with every new sale. Sometimes THAT does not happen. However it was Susposed to have one. GC

[Dynomite]

Originally Posted by GOLDCYLON

Nobody doubts you didn't get one. However these are soft goods and dealer prep items. Just like the console book, floor mats, demo cassettes and yes the rubber console cup. It was up to each dealer to make sure these went with every new sale. Sometimes THAT does not happen. However it was Susposed to have one. GC

Daryll...…. I think you have the correct Description of the "Cup Holder" issue

Without the cup rubber insert the "cup holder" definitely looks incomplete and loose change would definitely find its way under the console as I have observed many times when removing the console. I forget which "cup holder" contains the cigarette holder which cigarette holder I always replace with the rubber cup holder insert.

And you are also correct as I have tossed several soda cans with the rubber cup holder attached

[Mystic ZR-1]

Anyone know where NCRS officially stands on this important subject?

[TX '90 ZR1]

Originally Posted by Mystic ZR-1

Anyone know where NCRS officially stands on this important subject?

I have no clue where NCRS stands on this subject, but it is attracting so much attention I better get me one!
I guess I have always needed a "Can Condom" (as GOLDCYON calls them), just didn't know I did!!!

[Mystic ZR-1]

Yeh, me too.
Think I'll get 2 'cause they're so easy to lose....

[GOLDCYLON]

Originally Posted by Mystic ZR-1

Anyone know where NCRS officially stands on this important subject?

Honestly they don't care. It's not a point deduction at this moment

[GOLDCYLON]

Originally Posted by Mystic ZR-1

Yeh, me too.
Think I'll get 2 'cause they're so easy to lose....

When you install it and use it as it was meant to be used you will quickly see why I call it what I call it. It fits like a glove to the bottom lol

[GOLDCYLON]

Originally Posted by Reichert

My 1990 didn't have with an insert either when I bought it - just the ash tray. But honestly, it seems wrong, as it is easy for stuff to fall through the hole when the tray is open and the console bezel screw is showing. So I bought a couple of the liners from corvette central. They are really flimsy but get the job done.

I was also missing those little triangle inserts for the seat position switches, which made me think the cup holder liner was also lost to time and neglect.

Normally the triangle inserts.. called light covers by GM were easily vacuumed up by folks cleaning up the console area. Trying to get dirt and grime out of those voids lines along by sides of the switches. If you are not doing the cleaning nobody is going to stop to pull the vacuum bag for recovery. When I bought my 90 it was missing the light covers as well.

[BigJohn]

Originally Posted by Mystic ZR-1

Anyone know where NCRS officially stands on this important subject?

Didn’t see you at Harry’s!

[geezer]

The official NCRS position is …. They did come with inserts!!! I too will have to obtain one.

Thanks all for your input!!