|
04-27-2018
|
#1 |
 
Join Date: Jul 2016
Location: Bloomington, MN
Posts: 127
|
What resonator is this?
I took the resonator out of my Borla Challenge system because I read on Marc's website that it's restrictive. I look inside and have never seen one like this and it's not like the one Marc describes. Did Borla change it's design?IMG_20170922_145053214.jpgIMG_20170922_145102110.jpg
Sent from my XT1710-02 using Tapatalk
__________________
1991 ZR-1 #520 Arctic White/Gray |
|
|
|
04-27-2018
|
#2 |
 
Join Date: Jul 2007
Location: Bartlett, IL
Posts: 7,169
|
Re: What resonator is this?
can you take a picture of the body? is there any markings on it?
__________________
1990 Corvette ZR-1 #1051 Watson Headers (2" Primary) - Flowmaster Cats - Borla Catback Late Model IH - Plenum Coilovers - 4.10s Custom Interior NCM Lifetime Member #978 |
|
|
|
|
04-27-2018
|
#3 | |
|
Join Date: Jul 2016
Location: Bloomington, MN
Posts: 127
|
Re: What resonator is this?
Quote:
Sent from my XT1710-02 using Tapatalk
__________________
1991 ZR-1 #520 Arctic White/Gray |
|
|
|
|
|
04-28-2018
|
#4 |
 
Join Date: May 2005
Location: Georgia Mountains
Posts: 927
|
Re: What resonator is this?
I think it's probably a Borla resonator. I use to have the standard 2.5 Borla as well as the Borla Challenge 2.75 and I believe both resonators merged into three hollow pipes inside the resonator casing. I haven't had them for awhile and doubt that I took any photos but if my memory is correct that was the internal structure of the Borla ... and yes, it probably had some restriction compared to a "normal" resonator or x-pipe. Exhaust sound is highly subjective but I always thought the Borla sound was decent enough.
Last edited by Gunny; 04-28-2018 at 12:47 AM. Reason: typo |
|
|
|
 |
|
|
Linear Mode
