Service Ride Control light reset

[Billy Mild]

Originally Posted by mike100

The service ride control light will set if you have more than 3 engine starts and no vehicle VSS (speed signal from transducer in the trans). You have to drive the car (even if up on jacks) like 4 mph to clear that condition.

The light stayed on after unplugging the battery for the entire night.

[Billy Mild]

I just swapped the actuators and tried to reset the light. I am pretty sure I am doing this wrong.

When I do the reset sequence sometimes the light will go off for 1 second then come right back on. Does that mean the issue is still present or the sequence is off?

[Billy Mild]

http://www.ajusa.com/

Has anyone used them for suspension parts?

They are $100 cheaper for a set of 4 shocks.

[RussMcB]

Yes. That's where I recently bought mine and they were the best prices I found. Shipping was timely, IIRC.

Here's where I learned about them: http://zr1.net/forum/showthread.php?...ighlight=ajusa

[dredgeguy]

Originally Posted by Billy Mild

http://www.ajusa.com/

Has anyone used them for suspension parts?

They are $100 cheaper for a set of 4 shocks.

I purchased 4 shocks from them last month and Wazoo installed last weekend. Paid $737.24 with free shipping. Currently have the Service Ride Control light on but understand that it takes some time for the system to relearn.

[Billy Mild]

Once again I had the car up on jackstands, and unplugged the battery for multiple days. Could it be possible that my actuators are not in the right position on top of the shocks?

Any suggestions?

[Billy Mild]

I got Cliffs tester yesterday and fired it up. I cleared the codes, but one still remains. Code 14. Right front out of time. Does that mean the actuator is bad?