ZR-1 Net Registry Forums  

Go Back   ZR-1 Net Registry Forums > C4 ZR-1 > C4 ZR-1 Technical Postings

Reply
 
Thread Tools Display Modes
Old 08-09-2014   #31
WARP TEN
 
WARP TEN's Avatar
 
Join Date: Apr 2007
Location: Lake Bluff, IL
Posts: 2,096
Default Re: exhaust

Quote:
Originally Posted by KILLSHOTS View Post
The stock exhaust was designed to muffle sound, of course. But it was also tuned to eliminate the inherent resonance baked into our cars. It hits hard in the 1800ish RPM range and again in the 3400ish RPM range. The resonator was tuned to help part of it and the mufflers were tuned to help the other part of it. The exact details don't matter, but to answer your question somewhat succinctly, the Corsa system was designed in much the same way, except with much less restriction. What you have in the Corsa is a system that is somehow as effective at quelling resonance at all RPM as the stock system, but still causes virtually NO restriction. It is quiet at part-throttle but straight-pipe loud at full-throttle. Any exhaust can sound throaty or be "open" but in my opinion, the Corsa is brilliant because it just does everything right.
Chris is right. Over 20-odd years of owning ZR-1s, I tested and used a half a dozen systems and the Corsa was the best aftermarket system for flow (HP), sound and lack of resonance. Designed like the stock system to eliminate the resonance at the two rpm points that our cars really have it. Had Corsas for probably 12-15 years total. However as most of you know by now, I finally went back to the stock 95 system with electric cutouts for racing and just making noise when I want to. Usually run with them about1/3 open, but close them when I come back into our subdivision to appease my wife. Really like the set up. Quiet when I want it (say a long trip) and as noisy as I want other times. Headers, no cats, when open basically a straight through system as the stock resonator has little flow resistance. --Bob
__________________
2016 Long Beach Red Z06 #10281 "POPS Z"
1995 Polo Green #409 "WARP TEN"--Haibeck 350/510 package, 4.10s, Hurst, Stock Exhaust with QTP Cutouts
--Sold but still running strong
1993 Quasar Blue #161 "HIL KING"
--Sold but still running strong, now with more than 120,000 miles
1967 Marlboro Maroon/Saddle Corvette Coupe 300 hp/4-spd
--Sold a long time ago
ZR-1 Net Registry Founding Member #95
NCM Lifetime Member
Favorite Quote--Attributed to Mickey Thompson:
"Too Much Horsepower is Almost Enough"
WARP TEN is offline   Reply With Quote
Old 08-09-2014   #32
1990 quasar blue
 
Join Date: Feb 2004
Location: Ma
Posts: 404
Default Re: exhaust

Quote:
Originally Posted by KILLSHOTS View Post
The stock exhaust was designed to muffle sound, of course. But it was also tuned to eliminate the inherent resonance baked into our cars. It hits hard in the 1800ish RPM range and again in the 3400ish RPM range. The resonator was tuned to help part of it and the mufflers were tuned to help the other part of it. The exact details don't matter, but to answer your question somewhat succinctly, the Corsa system was designed in much the same way, except with much less restriction. What you have in the Corsa is a system that is somehow as effective at quelling resonance at all RPM as the stock system, but still causes virtually NO restriction. It is quiet at part-throttle but straight-pipe loud at full-throttle. Any exhaust can sound throaty or be "open" but in my opinion, the Corsa is brilliant because it just does everything right.
Thanks Chris. The reason I was wondering was because the guys running the NPP tips on a 3" system with X-pipe all have little to no resonance as long as that one tip on the mufflers stay closed.

Ed, it would seem that the 40 series would be the cheapest way to get more sound. I bellieve they're still aluminum so weight should be similar. Sorry I took this a little off topic.
__________________
1990 ZR1 #2574
Medium Quasar Blue Metallic
1 of 19
1990 quasar blue is offline   Reply With Quote
Old 08-09-2014   #33
KILLSHOTS
 
Join Date: Feb 2014
Location: AZ
Posts: 860
Default Re: exhaust

Quote:
Originally Posted by edram454 View Post
true but.... the corsa 1300.00 compared with the two 40 series mufflers at 160.00. quite a difference.. might be worth a shot?
Certainly true, Ed. I felt the same way, so I started making changes to my stock system. I got a great sound but it was pissing-off-the-neighbors loud, and since my only "mufflers" were the cats, the whole system had to go when I installed headers. Those "experiments" didn't cost me a whole lot, but when I finally decided to spend the dough and install the right system, what I had spent on the experiments ended up wasted money. If I had it to do over again, I'd have gone straight to headers and Corsa and saved some time and money.
KILLSHOTS is offline   Reply With Quote
Old 08-11-2014   #34
OregonDude37
 
Join Date: Jun 2014
Location: Hendersonville NC
Posts: 5
Default Re: exhaust

I went with the cat back Billy Boat 3" X-pipe exhaust system on my ZR - result was impressive. Although I cannot tell you how much improvement in terms of HP, I can tell you the car feels better under full throttle and although there is substantial drone at certain RPM's, the end result makes me smile! The look from the rear is also impressive.Cost was right at $1,000.
__________________
Dave Watson
2003 C5 Indy 500 Pace Car

1990 ZR1 #2683
Red on Red
Upgraded exterior trim 91-95
91 Saw Blade wheels
Painted/clear engine
B&B Exhaust
Accel Injectors
Haibeck Chip
K&N Filter
Nitto 555's
:proud:
OregonDude37 is offline   Reply With Quote
Old 08-11-2014   #35
Paul Workman
 
Paul Workman's Avatar
 
Join Date: Nov 2007
Location: Squires (near Ava MO in the Mark Twain N'tl Forest) - Missouri
Posts: 6,493
Default Re: exhaust

Quote:
Originally Posted by 1990 quasar blue View Post
With the Corsa system is it the resonator that reduces the drone? I ask because it is straight through. I thought what really helped the Corsa be drone free was the fact that they only flow through one pipe in the mufflers....*
If you look closely at the Corsa Resonator (specifically) you'll see a circular slot opening in the pipe section near the front of each of the resonator pipes. Like blowing air over the top of a pop bottle, a resonance is generated, dependent on the internal dimensions of the resonator - not unlike a pipe organ.

As it happens, the wave pulses created within the resonator cancel those exhaust pulses of the same frequency - and it occurs at that slot in the through pipe you see in the resonator.

And, IIRC, the mufflers too have (Helmholtz) resonators in them; shorter than the those in the resonator; designed to address the resonance occurring around 34K RPM.

Google "Helmholtz Resonator" for an in depth reading and how it is used for noise cancellation.
__________________
Good carz, good food, good friendz = the best of timez!

90 #1202
"FBI" top end ported & relieved
Cam timing by "Pete the Greek"
Sans secondaries
Chip & dyno tuning by Haibeck Automotive
SW headers, X-pipe, MF muffs

Former Secretary, ZR-1 Net Registry
Paul Workman is offline   Reply With Quote
Old 08-11-2014   #36
edram454
 
edram454's Avatar
 
Join Date: Nov 2013
Location: ..
Posts: 693
Default Re: exhaust

It looks like when I do decide to do a change, I will go with a muffler swap from my 60 series flowmaster to an original 40 series old style flowmaster exhaust. I know I will hear a significant difference in agressive tone and rumble. I will keep the rest of my flowmaster system including the resonators to limit drone somewhat. I drove my car today with flowmaster force II system and it is somewhat loud and under wot aggressive but I just want more. I dont drive her much so when I do, I want the looks, the power and the sound, plenty of sound. I should cost my around 400 dollars to swap mufflers and add tips. I cant believe that tips have become so expensive. they average 60 to 100+ bucks. I think this should work. My car is great and sounds good now but with this new setup it will be very impressive sounding. rumpty-thump!!

ed ramos #3028
edram454 is offline   Reply With Quote
Old 08-11-2014   #37
KILLSHOTS
 
Join Date: Feb 2014
Location: AZ
Posts: 860
Default Re: exhaust

Quote:
Originally Posted by edram454 View Post
It looks like when I do decide to do a change, I will go with a muffler swap from my 60 series flowmaster to an original 40 series old style flowmaster exhaust. I know I will hear a significant difference in agressive tone and rumble. I will keep the rest of my flowmaster system including the resonators to limit drone somewhat. I drove my car today with flowmaster force II system and it is somewhat loud and under wot aggressive but I just want more. I dont drive her much so when I do, I want the looks, the power and the sound, plenty of sound. I should cost my around 400 dollars to swap mufflers and add tips. I cant believe that tips have become so expensive. they average 60 to 100+ bucks. I think this should work. My car is great and sounds good now but with this new setup it will be very impressive sounding. rumpty-thump!!

ed ramos #3028
Just FYI Ed, when you do this, you will be keeping the most restrictive portion of the Flowmaster system, which is the resonator. Also, since you plan on changing the mufflers, you may experience more drone, as your exhaust was designed as a complete "system" and therefore, Flowmaster probably took the drone characteristics of the LT5 (and the C4, in general) into account. You'll be altering that.

Best of luck with the mods. I hope you find the sound you're looking for!
KILLSHOTS is offline   Reply With Quote
Old 08-11-2014   #38
edram454
 
edram454's Avatar
 
Join Date: Nov 2013
Location: ..
Posts: 693
Default Re: exhaust

the flowmaster tech said that the resonator is not that restrictive. He said that in testing that there was not that much difference with or without the resonator. He said that the resonator is in place to change the pitch of the sounds and play them off each other so the noise in the cabin would not be too loud. The resonators are just under the floor in the cabin of the car. The mufflers have baffles inside unlike corsa that is straight through with material around the pipe inside the muffler, maybe it is the muffler where there might be some restriction. The muffler used in the zr1 flowmaster kit is a 60 series muffler. It has 3 chambers so the exhaust gets tossed around quite a bit inside that muffler as noise is bumping off several baffles canceling each other out until it finally exits the muffler. the corsa goes straight through and depends on the material that is wrapped around the perforated pipe inside the muffler to eliminate the noise. Over time, the corsa's material inside the muffler will break down and the exhaust will become louder.

the 40 series is a 2 chamber design so it will be louder and it will have more drone and less back pressure etc.. but it is ok. I believe it will work and its worth the shot. If for whatever reason I don't like it then I will opt for the corsa.

ed ramos #3028

Last edited by edram454; 08-11-2014 at 03:50 PM.
edram454 is offline   Reply With Quote
Old 08-11-2014   #39
Schrade
 
Join Date: Dec 2012
Location: NC
Posts: 1,786
Default Re: exhaust

I just did the first test of drone reduction with the extra-foam / painted top, over glasstop.

I did a recording with each. It was a little quieter with the painted top, and when I played it in a media player with graphic EQ, it IS slightly lower volume.

Next test with cork underlayment under interior cargo carpet area. I don't think it will reduce drone enough more, to take the edge off...

And I can't get over the sound like an exhaust leak. HAS TO be the crossover section. There is no exhaust leaking - of that I'm sure...
__________________
I'm getting my snappics / threads removed blindly as fast as I can, to get in compliance with copyright / license TOS on the boards here (lots of FSM pages and other copyright / license violations on my part; sorry guys). And thanks to all the guys who didn't whine when I posted those FSM copyrighted / licensed stuff in my threads...

( :thumbsup: [b]and to think I complied with a mod's request to delete a pic of him in a Challenge Car in NCM Museum, so he wouldn't get in hot water)[/b]

Thanks to several guys here for sending parts FREE; BearlyFlying, WeGone, Geezer, GoldCylon, and more there, TonyD, mike100, fletchusmc...

1990 #2794; 4L60e Stage V by RPM Transmission, TCI Dedicated TCM, OBX Stainless, Power Effects 3"

[IMG]https://lh5.googleusercontent.com/-GHpfzty7DVU/UQn-0Ru2xAI/AAAAAAAAA14/08mz1p4QLD4/s445/Screenshot-5.png[/IMG]
Schrade is offline   Reply With Quote
Old 08-11-2014   #40
XfireZ51
 
Join Date: May 2007
Location: Chicagoland, IL
Posts: 9,709
Default Re: exhaust

I would try some styrofoam or foam over the top of the spare tire so that it deadens any resonance of the hatch floor. Could it be that the spare tire carrier creates a BOOOM Box under the hatch floor?
__________________
[SIGPIC][/SIGPIC]Former Membership Chairman
Former ZR-1 Registry - BOD
1972 Corvette 4speed base Coupe SOLD long time ago
1984 Corvette Z-51/4+3 SOLD
1992 Corvette ZR-1 Aqua/Gray #474 SOLD
1992 Corvette ZR-1 Black Rose/Cognac #458
2014 Honda VFR Interceptor DX
XfireZ51 is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 05:42 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2020