ZR-1 Net Registry Forums  

Go Back   ZR-1 Net Registry Forums > C4 ZR-1 > C4 ZR-1 Technical Postings

Reply
 
Thread Tools Display Modes
Old 05-19-2010   #1
hihok9
 
Join Date: Jul 2005
Posts: 49
Default clutch disc pic please

Installing my clutch disc with hydraulic throwout bearing and had no old one to go by..... Assembly manual is not clear and RAM directions are poor..... anybody got a pic of which side goes toward engine. Don't want to make that mistake. Thanks!
hihok9 is offline   Reply With Quote
Old 05-19-2010   #2
Wide_One
 
Join Date: Dec 2004
Location: San Ramon Ca
Posts: 32
Default Re: clutch disc pic please

Are you replacing the slave cylinder with the ram kit?
Wide_One is offline   Reply With Quote
Old 05-19-2010   #3
rhipsher
 
rhipsher's Avatar
 
Join Date: Aug 2008
Location: Houston 90 Red ZR-1
Posts: 2,320
Default Re: clutch disc pic please

Here you go.




rhipsher is offline   Reply With Quote
Old 05-19-2010   #4
A26B
 
A26B's Avatar
 
Join Date: Dec 2003
Location: Arcadia,OK
Posts: 3,394
Default Re: clutch disc pic please

I think he wanted photos of the disc.
__________________
Jerry Downey
JERRYS LT5 GASKETS & PARTS
http://www.jerrysgaskets.com
1994 ZR-1, Black/Black, Lingenfelter Aerobody, 416cu in, 3.91 gears, coil-over susp, Brembo brakes, etc.
2016 Black-Red, 3LT-Z51 Auto 8-speed.
A26B is offline   Reply With Quote
Old 05-19-2010   #5
rhipsher
 
rhipsher's Avatar
 
Join Date: Aug 2008
Location: Houston 90 Red ZR-1
Posts: 2,320
Default Re: clutch disc pic please

Quote:
Originally Posted by A26B View Post
I think he wanted photos of the disc.
oops. that's easy enough without a photo. most disks have a sticker that says flywheel side. Look at your disk where the 26 tooth spline is. One side is flush with the face and the other protrudes about an inch. the protruding side faces your flywheel/engine.
rhipsher is offline   Reply With Quote
Old 05-19-2010   #6
hihok9
 
Join Date: Jul 2005
Posts: 49
Default Re: clutch disc pic please

Thanks! That's what I was looking for. There is a small collar on the side I put toward the engine.... maybe a half inch... and the side toward the tranny was a couple flat plates maybe 1/4 in wide six inches across, wide and smooth, not like the collar on the other side. The slave is the throwout, uses the stock firewall master. I had to cut the boss off the bellhousing for the slave to make clearance in my application. The hydraulic system came with aluminum flywheel as well. That's when I found out all about having to get shorter bolts ..... Learning as I go.
hihok9 is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:30 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2020