|
09-08-2009
|
#1 |
Join Date: Jul 2007
Location: Anchorage, AK
Posts: 106
|
WTB Passenger Side Rear Bumper Molding
This is for my 1992 ZR-1. Very minor Bumper Thumper, but I want to replace the damaged part if I can, not try to have it repaired.
Rich Ballou
__________________
REBelZ '92 ZR-1 Yellow/Black #031 |
|
|
|
09-08-2009
|
#2 |
 
Join Date: Dec 2005
Posts: 692
|
Re: WTB Passenger Side Rear Bumper Molding
Are they side specific?? Do you know?
Good Luck!! Rick |
|
|
|
|
09-08-2009
|
#3 |
|
Join Date: Jul 2007
Location: Anchorage, AK
Posts: 106
|
Re: WTB Passenger Side Rear Bumper Molding
In the ZR-1 parts PDF I have it lists LH 10174848 & RH 10174849, so I have to assume you can't just flip one over 180° to make it fit the other side. I don't know that for a fact though. I think if I was designing those that is the way I would do it. On all the outer body molding just flip it to fit the other side.
Rich
__________________
REBelZ '92 ZR-1 Yellow/Black #031 |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
