Drive Train Lifting - ZR-1 Net Registry Forums

tf95ZR1 · 12-24-2005

OK, one last question for now:
When I step on it hard I feel the gear shift lever lifting more than I remember it lifting before. I'd say 1/2 to 1 inch.
I got under the car and checked the C beam bolts front and rear-all tight.
Thank goodness for the B. Boudreau C beam plates- makes it a LOT easier.
Think it could be the motor mounts, or is this lift normal? Any easy way to check? TIA Don't think the plenum is hitting the hood......
Ted Feder
95 ZR1 #106
So. Cal.

tf95ZR1 · 12-27-2005

The (private) consensus is that either:
1) The c beam bolts are loose/stripped
2) A problem with the c beam itself.
Bolts seem tight, so........
Is the c beam the same for all ZR1 years 1990-1995?
Are they different than other C4 c beams?
Thanks,
Ted

12-27-2005	#2
tf95ZR1 Join Date: Aug 2005 Location: Northridge, CA Posts: 1,461	Re: Drive Train Lifting The (private) consensus is that either: 1) The c beam bolts are loose/stripped 2) A problem with the c beam itself. Bolts seem tight, so........ Is the c beam the same for all ZR1 years 1990-1995? Are they different than other C4 c beams? Thanks, Ted

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-24-2005	#1
tf95ZR1 Join Date: Aug 2005 Location: Northridge, CA Posts: 1,461	Drive Train Lifting OK, one last question for now: When I step on it hard I feel the gear shift lever lifting more than I remember it lifting before. I'd say 1/2 to 1 inch. I got under the car and checked the C beam bolts front and rear-all tight. Thank goodness for the B. Boudreau C beam plates- makes it a LOT easier. Think it could be the motor mounts, or is this lift normal? Any easy way to check? TIA Don't think the plenum is hitting the hood...... Ted Feder 95 ZR1 #106 So. Cal. Last edited by tf95ZR1; 12-24-2005 at 03:14 AM.