ZR-1 Net Registry Forums  

Go Back   ZR-1 Net Registry Forums > C4 ZR-1 > C4 NCRS for ZR-1s

Reply
 
Thread Tools Display Modes
Old 04-07-2022   #11
AirbusDriver
 
Join Date: Jul 2016
Location: Harrodsburg, KY
Posts: 448
Default Re: 1990 ZR-1 #2456 Original Components

Delivered with, assembly line air filter...






AirbusDriver is offline   Reply With Quote
Old 04-07-2022   #12
DRM500RUBYZR-1
 
DRM500RUBYZR-1's Avatar
 
Join Date: Sep 2008
Location: Mullica Hill, New Jersey
Posts: 2,602
Default Re: 1990 ZR-1 #2456 Original Components

GREAT pictures!!!

INTERESTING!!!

Puzzled about the top.
The masking tape was done at the factory, and should match the last numbers of VIN.

They should be stamped on the roof frame as well.
If the stamped number equals the VIN that would be good, but still would not explain the 470 on the tape.

Switched / mismatched at dealer perhaps??

Thanks for sharing the pictures with the progress!!


Marty
DRM500RUBYZR-1 is offline   Reply With Quote
Old 04-07-2022   #13
AirbusDriver
 
Join Date: Jul 2016
Location: Harrodsburg, KY
Posts: 448
Default Re: 1990 ZR-1 #2456 Original Components

I've searched for the VIN on the plexi top. Obviously not looking in the proper area.
I have another 90 with two tops (44 miles) and I found the VIN. The other 90 has different markings, if I remember correctly. I'll wonder down stairs and get a shot of it, later.
I tried to make sense of the # on the tape but am just going to leave well enough alone. Several pieces of old masking tape in the car. I'm trying not to disturb what's there.
AirbusDriver is offline   Reply With Quote
Old 04-07-2022   #14
AirbusDriver
 
Join Date: Jul 2016
Location: Harrodsburg, KY
Posts: 448
Default Re: 1990 ZR-1 #2456 Original Components

There is an ID label on the rear fiberglass spring. It is on the top driver side. Lousy pic...


AirbusDriver is offline   Reply With Quote
Old 04-07-2022   #15
TX '90 ZR1
 
TX '90 ZR1's Avatar
 
Join Date: Oct 2017
Location: TX
Posts: 2,047
Default Re: 1990 ZR-1 #2456 Original Components

Quote from Marty :
INTERESTING!!!

Puzzled about the top.
The masking tape was done at the factory, and should match the last numbers of VIN.

They should be stamped on the roof frame as well.
If the stamped number equals the VIN that would be good, but still would not explain the 470 on the tape.

Switched / mismatched at dealer perhaps?? (End Quote)

Marty,
The glass top for my '90 has that piece of masking tape on it also. Written on the tape is "987". The number of my car is "0442" and the "0442" is also stamped in the frame of the glass top in the proper place. I've often wondered why the masking tape was there and why is was marked as it is.
Here's a pic:
1217-6.jpg
__________________
Kenny
1990 #442

Last edited by TX '90 ZR1; 04-07-2022 at 06:44 PM. Reason: spelling
TX '90 ZR1 is offline   Reply With Quote
Old 04-07-2022   #16
AirbusDriver
 
Join Date: Jul 2016
Location: Harrodsburg, KY
Posts: 448
Default Re: 1990 ZR-1 #2456 Original Components

Kenny
What is the info on the center rear portion of your glass top? Is it Almac?
Regards,
Mark
PS...I enjoy a good mystery
AirbusDriver is offline   Reply With Quote
Old 04-07-2022   #17
DRM500RUBYZR-1
 
DRM500RUBYZR-1's Avatar
 
Join Date: Sep 2008
Location: Mullica Hill, New Jersey
Posts: 2,602
Default Re: 1990 ZR-1 #2456 Original Components

If either of you have the build sheet, perhaps it is the sequence number of the build.
Later cars seem to match.
Perhaps 90 was different?

Will refer to a C-4 NCRS Judge to see if they have any insight.

I too enjoy ZR-1 history mystery.

Great to see the AC Spark Plug markings.

Appreciate the pictures!

Very good progress!


Marty
DRM500RUBYZR-1 is offline   Reply With Quote
Old 04-07-2022   #18
AirbusDriver
 
Join Date: Jul 2016
Location: Harrodsburg, KY
Posts: 448
Default Re: 1990 ZR-1 #2456 Original Components

I have the build sheet for my other low mile ZR-1 but, dagnabbit, now I'm gonna have to remove the bronze top to see the tape #😜
Always something. Tomorrow, I'll get that done 👍
AirbusDriver is offline   Reply With Quote
Old 04-07-2022   #19
viper107
 
viper107's Avatar
 
Join Date: Dec 2019
Location: st louis mo
Posts: 749
Default Re: 1990 ZR-1 #2456 Original Components

We're is the stamping on the top at?
__________________
95 admiral blue z(sold)/ / 93 ruby z(sold) 91 steel blue z/95 aqua z haibeck 510, 91 callaway 415 areobody #5
viper107 is offline   Reply With Quote
Old 04-07-2022   #20
TX '90 ZR1
 
TX '90 ZR1's Avatar
 
Join Date: Oct 2017
Location: TX
Posts: 2,047
Default Re: 1990 ZR-1 #2456 Original Components

Quote:
Originally Posted by AirbusDriver View Post
Kenny
What is the info on the center rear portion of your glass top? Is it Almac?
Regards,
Mark
PS...I enjoy a good mystery
Mark,
I'll have to unwrap it and look. Will let you know.
__________________
Kenny
1990 #442
TX '90 ZR1 is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:48 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright ZR-1 Net Registry 2020