10-02-2019 | #21 |
Join Date: Dec 2018
Location: Long Beach, CA
Posts: 73
|
Re: 1990 ZR-1 Issues
So, I took off the air setup, and noticed one seemed to leak slightly when sucking, and had a faint taste of gas. Can I just remove the diverter and connect the two together, or do I need to block them individually to delete the air setup?
|
10-02-2019 | #22 |
Join Date: May 2007
Location: Chicagoland, IL
Posts: 9,708
|
Re: 1990 ZR-1 Issues
If u disable the A.I.R., u also need to tell the ECM u r doing that. So a minor change in the calibration is called for.
__________________
[SIGPIC][/SIGPIC]Former Membership Chairman Former ZR-1 Registry - BOD 1972 Corvette 4speed base Coupe SOLD long time ago 1984 Corvette Z-51/4+3 SOLD 1992 Corvette ZR-1 Aqua/Gray #474 SOLD 1992 Corvette ZR-1 Black Rose/Cognac #458 2014 Honda VFR Interceptor DX |
10-02-2019 | #23 |
Join Date: Dec 2018
Location: Long Beach, CA
Posts: 73
|
Re: 1990 ZR-1 Issues
I was told that this wouldn't affect anything. Either way, I removed the diverter and connected the two together, and it honestly made the right bank more lean, or maybe I'm crazy. I'm open on what to test next. I noticed the cross counts for the left bank were like 10-15, vs the right bank was 0-2.
|
10-02-2019 | #24 |
Join Date: Sep 2012
Location: United Kingdom
Posts: 68
|
Re: 1990 ZR-1 Issues
You said originally that 'I got my zr-1 and it never ran right, but after sitting for a few months it's a lot worse'.
I guess that you purchased it earlier this year. Did you get any history with the car that could point to a resolution? Could it be a mechanical issue that is 'tricking' the sensors? |
10-02-2019 | #25 |
Join Date: Dec 2018
Location: Long Beach, CA
Posts: 73
|
Re: 1990 ZR-1 Issues
I did not get any history with the car no. I did notice that the INT creeps up ONLY at idle. I changed what I thought was my leaky check valve with a new one and no fix. Although I JUST found out both my resonators are cracked.
|
10-02-2019 | #26 |
Join Date: Dec 2003
Location: Arcadia,OK
Posts: 3,394
|
Re: 1990 ZR-1 Issues
BOTH??? resonsators Only one resonator (in the middle) & 2 mufflers @ rear. Are you perhaps referring to the catalytic converters, welded into the exhaust manifolds?
__________________
Jerry Downey JERRYS LT5 GASKETS & PARTS http://www.jerrysgaskets.com 1994 ZR-1, Black/Black, Lingenfelter Aerobody, 416cu in, 3.91 gears, coil-over susp, Brembo brakes, etc. 2016 Black-Red, 3LT-Z51 Auto 8-speed. |
10-02-2019 | #27 |
Join Date: Dec 2018
Location: Long Beach, CA
Posts: 73
|
Re: 1990 ZR-1 Issues
Hi, yes both. I have a Corsa cat back. I doubt that would cause my issues though. What should I test next? I'm really stumped.
|
10-02-2019 | #28 |
Join Date: May 2007
Location: Chicagoland, IL
Posts: 9,708
|
Re: 1990 ZR-1 Issues
If resonators are leaking they could suck fresh sir into the exhaust which could impact the operation of the O2s.
__________________
[SIGPIC][/SIGPIC]Former Membership Chairman Former ZR-1 Registry - BOD 1972 Corvette 4speed base Coupe SOLD long time ago 1984 Corvette Z-51/4+3 SOLD 1992 Corvette ZR-1 Aqua/Gray #474 SOLD 1992 Corvette ZR-1 Black Rose/Cognac #458 2014 Honda VFR Interceptor DX |
10-02-2019 | #29 |
Join Date: Dec 2018
Location: Long Beach, CA
Posts: 73
|
Re: 1990 ZR-1 Issues
Even though they're like 3 feet downstream?
|
10-02-2019 | #30 |
Join Date: May 2007
Location: Chicagoland, IL
Posts: 9,708
|
Re: 1990 ZR-1 Issues
Its happened to me with a leak at the muffler. Idle and Decel are two pointa where engine vacuum is at its highest. It can pull fresh air past the O2s creating a “false lean” condition. That in turn will cause the ECM to richen the AFR.
__________________
[SIGPIC][/SIGPIC]Former Membership Chairman Former ZR-1 Registry - BOD 1972 Corvette 4speed base Coupe SOLD long time ago 1984 Corvette Z-51/4+3 SOLD 1992 Corvette ZR-1 Aqua/Gray #474 SOLD 1992 Corvette ZR-1 Black Rose/Cognac #458 2014 Honda VFR Interceptor DX |
Thread Tools | |
Display Modes | |
|
|