WTB crank sensor connextor

[-=Jeff=-]

I am looking for the 3 wire crank sensor connector found on the Ignition Module. I can find the harness side but I want the module side connector.. thanks

Image1556229503.716517.jpg


Sent from my iPhone using ZR-1 Net Registry

[spork2367]

https://www.jerrysgaskets.com/connec...-1990-95-12b5/

[-=Jeff=-]

Thanks but I need the IM side of the connector

[spork2367]

Originally Posted by -=Jeff=-

Thanks but I need the IM side of the connector

I guess I'm unclear as to what you're looking for. The connector in the link is the connector that plugs into the left rear of the module. The connector on the module is molded into the entire case.

Are you just looking for a female connector that would match the cases connector?

If so, it's this one:

https://theelectricaldepot.com/weath...0ae6902b383fa4

[secondchance]

https://www.whiteproducts.com/fusible_link_wire.shtml

Go to the website and download online catalog. Looks like Metri-pack 1508.

[-=Jeff=-]

Originally Posted by spork2367

I guess I'm unclear as to what you're looking for. The connector in the link is the connector that plugs into the left rear of the module. The connector on the module is molded into the entire case.

Are you just looking for a female connector that would match the cases connector?

If so, it's this one:

https://theelectricaldepot.com/weath...0ae6902b383fa4

Yes I want the female connector to match the connector on the harness..

I have the one you posted (series 150 and I don't believe it fits.. I will check again, but if I recall it is too wide

Yun,

1508 is the harness side connector, yes, it is a series 150.2 pull to seat. I have not been able to find the female mate to it, that is what I need

essentially I want to plug it into the harness

[secondchance]

http://www.dstgateway.com/ACDelcoConnectorsV2/#/catalog

Also check PT 2353.

[-=Jeff=-]

Originally Posted by secondchance

http://www.dstgateway.com/ACDelcoConnectorsV2/#/catalog

Also check PT 2353.

that might b too wide, but again, I need the mate. I think I might just have to cut the harness, and use the 150 series, then make an 'adapter' to the OEM Crank sensor connector..

[secondchance]

Originally Posted by -=Jeff=-

that might b too wide, but again, I need the mate. I think I might just have to cut the harness, and use the 150 series, then make an 'adapter' to the OEM Crank sensor connector..

It's tough to tell sometime looking at the catalog.
Are you looking for the female side? For your custom ignition module?

[-=Jeff=-]

Yes