|
06-20-2018
|
#1 |
 
Join Date: Nov 2007
Location: Sunshine State
Posts: 1,071
|
Sway Bar Sizes
Using my ghetto plastic veneer caliper, I came up with what I think is a 24mm rear and a 26mm front for my sway bar sizes. Does that seem correct? Did a 90 ZR-1 come with any other sizes for the sway bars?
Thanks, John 
__________________
[B]1990 #2815[/B] [COLOR="Red"][B]Red/Red[/B][/COLOR] Ported Plenum & IH (by Pete) Haibeck Chip Rebuilt FPR (by Phil) FIC Injectors Watson LT Headers 3" Stainless Works exhaust Lingenfelter Open Air Lid Bill B Built Transmission Shifter & C Beam Plates [FONT=Impact][COLOR=red]1992 [COLOR=black]#[/COLOR] 091[/COLOR][/FONT] [FONT=Impact][COLOR=#ff0000]Red/[COLOR=silver]Gray[/COLOR][/COLOR][/FONT] [B]SOLD[/B] |
|
|
|
06-30-2018
|
#2 | ||
 Join Date: Jun 2005
Location: CenCoast California
Posts: 899
|
Re: Sway Bar Sizes
Quote:
Quote:
__________________
Hib Halverson Technical Writer former owner 95 VIN 0140 current owner 19 VIN 1878 |
||
|
|
|
|
06-30-2018
|
#3 | |
|
Join Date: Nov 2007
Location: Sunshine State
Posts: 1,071
|
Re: Sway Bar Sizes
Quote:
__________________
[B]1990 #2815[/B] [COLOR="Red"][B]Red/Red[/B][/COLOR] Ported Plenum & IH (by Pete) Haibeck Chip Rebuilt FPR (by Phil) FIC Injectors Watson LT Headers 3" Stainless Works exhaust Lingenfelter Open Air Lid Bill B Built Transmission Shifter & C Beam Plates [FONT=Impact][COLOR=red]1992 [COLOR=black]#[/COLOR] 091[/COLOR][/FONT] [FONT=Impact][COLOR=#ff0000]Red/[COLOR=silver]Gray[/COLOR][/COLOR][/FONT] [B]SOLD[/B] |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
