Shift Lite A Pillar Install - ZR-1 Net Registry Forums

XfireZ51 · 08-13-2011

This is a Raptor I am using but the Harlan is nearly identical. It uses the diag harness connector for switched power and tach feed. Then a simple extension to ground somewhere on the block. I use the MAP sensor mounting bolt. Plug and Play.

Easy routing through door gasket and then tucked between pillar and IP pad. "A" pillar location also makes light easily accessible for changing shift points.

08-13-2011	#1
XfireZ51 Join Date: May 2007 Location: Chicagoland, IL Posts: 9,683	Shift Lite A Pillar Install This is a Raptor I am using but the Harlan is nearly identical. It uses the diag harness connector for switched power and tach feed. Then a simple extension to ground somewhere on the block. I use the MAP sensor mounting bolt. Plug and Play. Easy routing through door gasket and then tucked between pillar and IP pad. "A" pillar location also makes light easily accessible for changing shift points. Last edited by XfireZ51; 08-13-2011 at 04:02 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode