O2 extentions and header bolts - ZR-1 Net Registry Forums

mgbrv8 · 05-26-2011

I am making a set of O2 sensor extensions for my 91, is there a length I should not exceed or a optimum gauge wire I should use, I will make them equal length no matter what? Now I am also using stainless allen bolts on my stainless headers with stainless lock washers. Should I use the factory torque or should I go a touch more due to stainless being softer and possibility of stretch?

Dave

05-26-2011	#1
mgbrv8 Join Date: Jul 2009 Location: Texas Posts: 793	O2 extentions and header bolts I am making a set of O2 sensor extensions for my 91, is there a length I should not exceed or a optimum gauge wire I should use, I will make them equal length no matter what? Now I am also using stainless allen bolts on my stainless headers with stainless lock washers. Should I use the factory torque or should I go a touch more due to stainless being softer and possibility of stretch? Dave

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode