|
05-23-2011
|
#1 |
Join Date: Jan 2009
Location: Albuquerque
Posts: 43
|
Thinking of making some Aluminum pulleys
As the title says I am thinking of making 10 sets of aluminum billet pulleys. What I am thinking of making are: water pump , alt, If possible Power steering pulleys. Machined finish you can polish if you want then. Not sure what a set will cost or sell for but just seeing if there is any interest. Maybe the belt tentioner pulley also as an add on.
 Question should I speed up or slow down the water pump pulley? If so how much % wise. Thanks,Mike |
|
|
|
05-23-2011
|
#2 |
 
Join Date: Mar 2007
Location: Crystal Lake, IL
Posts: 7,194
|
Re: Thinking of making some Aluminum pulleys
How about an Under Drive for the ATI?
__________________
LGAFF 90 #966-150K miles-sold 92 #234-sold 1987 Callaway TT #17 1991 ZR-1 #1359 |
|
|
|
|
05-24-2011
|
#3 |
|
Join Date: Mar 2007
Location: Crystal Lake, IL
Posts: 7,194
|
Re: Thinking of making some Aluminum pulleys
I think you would want to slow it down due to cavitation at higher RPM, undrive I believe solves that issue
__________________
LGAFF 90 #966-150K miles-sold 92 #234-sold 1987 Callaway TT #17 1991 ZR-1 #1359 |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
