Spoke too soon, I recon. Bummer. - ZR-1 Net Registry Forums

Paul Workman · 07-19-2009

Thru my new un-restricted exhaust I hear a "tick" sound from the tailpipes, keeping time with the engine rotations. Pulling the plug wire on #8 results in little change in idle, but a significant drop in "tick" (or "ch-ch-ch", if you will). Whereas there was no change in the sound when I pulled each of the other plug wires, one at a time. This ain't good news, just now.

Some good news tho. There seems to be a marked reduction in the "buzz" sensation on the gear shift after installing new U joints and re-aligning the position of the trans tail. (Bill B's C-beam plates make fussing with the C-beam a piece of cake.)

[Sigh]. My fuel pressure issue remains as well. So, I guess I'll go out to the garage and swap pumps and socks.

NUTS!

P.

rhipsher · 07-19-2009

Sorry to hear that Paul. I fully expect to have some gremmlins after I putting mine back together after I get the P/P stuff back from powder coating. I'll be suprised if it fires up with out a hitch.

07-19-2009	#1
Paul Workman Join Date: Nov 2007 Location: Squires (near Ava MO in the Mark Twain N'tl Forest) - Missouri Posts: 6,466	Spoke too soon, I recon. Bummer. Thru my new un-restricted exhaust I hear a "tick" sound from the tailpipes, keeping time with the engine rotations. Pulling the plug wire on #8 results in little change in idle, but a significant drop in "tick" (or "ch-ch-ch", if you will). Whereas there was no change in the sound when I pulled each of the other plug wires, one at a time. This ain't good news, just now. Some good news tho. There seems to be a marked reduction in the "buzz" sensation on the gear shift after installing new U joints and re-aligning the position of the trans tail. (Bill B's C-beam plates make fussing with the C-beam a piece of cake.) [Sigh]. My fuel pressure issue remains as well. So, I guess I'll go out to the garage and swap pumps and socks. NUTS! P.

07-19-2009	#2
rhipsher Join Date: Aug 2008 Location: Houston, TX Posts: 2,314	Re: Spoke too soon, I recon. Bummer. Sorry to hear that Paul. I fully expect to have some gremmlins after I putting mine back together after I get the P/P stuff back from powder coating. I'll be suprised if it fires up with out a hitch.