|
|
|
11-18-2008
|
#1 |
Join Date: Jun 2006
Location: Thunderbolt, Ga.
Posts: 253
|
ZR1 rear spindle removal
Over the next weekend Im planning on removing a rear spindle from my 1990 ZR1 and was wondering if anyone here has tackled this? If so are there any special tools or procedures to follow? Any advice on making the job easy? Any help would be greatly appreciated.
-Patrick |
|
|
|
11-18-2008
|
#2 |
 
Join Date: Feb 2006
Location: San Antonio area
Posts: 1,179
|
Re: ZR1 rear spindle removal
You'll need a T55 (size?) Torx bit for the three bolts inside by the u-joint.
The FSM spec of 164 lb-ft torque spec for the spindle nut was later changed to 200. The FSM is helpful if you've never done one before.
__________________
“Buy the best example of what you want, and pay whatever it takes. That way, you cry only once.” ~ Bruce Meyer |
|
|
|
|
11-18-2008
|
#3 |
Join Date: Sep 2006
Location: lone pine and mammoth lakes
Posts: 1,407
|
Re: ZR1 rear spindle removal
i have put rear bearings in both my cars .i personally found it easier to just remove the whole housing to get at the t55 torx bolt otherwise its a tight squeeze. it takes about 2 hrs if you go slow and clean everything . an hr per side . not a hard job at all
|
|
|
|
|
11-18-2008
|
#4 |
|
Join Date: Jun 2006
Location: Thunderbolt, Ga.
Posts: 253
|
Re: ZR1 rear spindle removal
sweet, I look forward to it then. Thanks for the info.
__________________
IT IS THE FATE OF THE INNOCENT TO MEET WITH DEATH!!! |
|
|
|
 |
|
|
Hybrid Mode
