Travel Buddy 2 Drink Holder

[Usa2405]

The stock cupholders in my 95 are useless. I see a Travel Buddy 2 drink holder on several of the Corvette parts sites and am curious if anyone has experience with them. They seem to mount under the top lip of the console on the passenger side with a leg that seems to go down to the floor. Do they fit well? Do they stay in place? Do they damage the console?

I did a search and I found a few posts from people looking to buy a single holder that seems to be discontinued, but found nothing on the 2 drink version. Thanks is advance for helping out the new guy!

[HAWAIIZR-1]

I have these in my 95 for a long as I can remember. I had the single in my 90 but got the double for my 95 and so much better since it is good for more than just drinks when touring.

Do they fit well? Yes, there is a little bit of adjustment but not much.

Do they stay in place? Yes, a good snug fit.

Do they damage the console? No, the top is between panel and carpet.

[Usa2405]

Awesome! Thank you for the super quick and thoughtful response. I love this community.

[HAWAIIZR-1]

Originally Posted by Usa2405

Awesome! Thank you for the super quick and thoughtful response. I love this community.

You?re welcome and glad to help. Maybe this is a better shot. I just happen to be prepping for car show so easy to take a pic for you.

[mackguy]

I see these listed as 84-89 and 94-96...
Is there a solution for 93?

[secondchance]

Originally Posted by mackguy

I see these listed as 84-89 and 94-96...
Is there a solution for 93?

90 thru 93 have flying buttress and may be the reason skipped.

[HAWAIIZR-1]

Originally Posted by mackguy

I see these listed as 84-89 and 94-96...
Is there a solution for 93?

This is the one I had in my 90Z. I believe they are NLA? Maybe someone that has one can have it 3D printed?

https://www.fullthrottlecorvette.com...ck_p_2806.html

[dredgeguy]

I have the single Travel Buddy for my 92. They have been discontinued but used ones pop up once in a while on ebay. I have also seen some other type of cup holders that are 3D printed now available. I will try to find that listing for you.

[DaveK]

I have the same one as Charlie and Craig. I got a 2 cup adapter for it which works reasonably well, though it lifts it a little high. This is the adapter - https://www.amazon.ca/Multifunctiona...dp/B08TCG2LHG/

[dredgeguy]

Nice find on the adapter Dave. I just use my Travel Buddy to hold my phone. I have the Weathertech Cupfone pushed into the Travel Buddy that holds my phone securely so I can see GPS. Just like my Dad's rules, no drinking in the car allowed.