|
|
|
05-08-2016
|
#1 |
 
Join Date: Mar 2007
Location: Crystal Lake, IL
Posts: 7,195
|
DIS Fault Line Malfunction
So I had the intake off and then reassembled on the 90. I drove the car and although it ran fine(defining fine as, didn't die backfire, etc), it was way down on power; drove like an LT-1..even revved up. No codes.
After thinking it was a coil and not seeing any bent DIS pins that were obvious I pulled everything back apart to find there was a slightly bent pin, that had gone around one side of the female harness insert As there were no codes that this would be good to share, if you are down on power but have a driveable car this might be an area to look. Its the green wire on the DIS harness The car will also completely fail the inj balance test in this mode with a tech one
__________________
LGAFF 90 #966-150K miles-sold 92 #234-sold 1987 Callaway TT #17 1991 ZR-1 #1359 Last edited by LGAFF; 05-08-2016 at 09:43 PM. |
|
|
|
05-08-2016
|
#2 |
|
Join Date: May 2007
Location: Chicagoland, IL
Posts: 9,711
|
Re: DIS Fault Line Malfunction
It's called Limp Home mode. The ICM has timing hardwired into it for ECM faults.
__________________
[SIGPIC][/SIGPIC]Former Membership Chairman Former ZR-1 Registry - BOD 1972 Corvette 4speed base Coupe SOLD long time ago 1984 Corvette Z-51/4+3 SOLD 1992 Corvette ZR-1 Aqua/Gray #474 SOLD 1992 Corvette ZR-1 Black Rose/Cognac #458 2014 Honda VFR Interceptor DX |
|
|
|
|
05-09-2016
|
#3 |
|
Join Date: Mar 2007
Location: Crystal Lake, IL
Posts: 7,195
|
Re: DIS Fault Line Malfunction
i've been in limp home before, never seen it w/o a ses light....
__________________
LGAFF 90 #966-150K miles-sold 92 #234-sold 1987 Callaway TT #17 1991 ZR-1 #1359 |
|
|
|
 |
|
|
Hybrid Mode
