|
|
|
05-09-2015
|
#1 |
|
Join Date: Apr 2015
Location: Northwest AR
Posts: 95
|
Hailbeck Chip Help
I sent Marc an email, but being the weekend I may not hear from him. I just installed his chip in my 90. Car starts, runs for a few seconds and then dies accompanied by the service engine light (code 22). Does this over and over and will not continue running. I triple checked all of the connections, etc. Any ideas?
Edit, guess my car has gremlins. Put factory chip back in, car ran fine, put Hailbeck back in, and then ran fine. Last edited by SteveCanyon; 05-09-2015 at 03:05 PM. |
|
|
|
05-09-2015
|
#2 | |
  
Join Date: Aug 2009
Location: South Dakota/California
Posts: 3,809
|
Re: Hailbeck Chip Help
Quote:
|
|
|
|
|
|
05-09-2015
|
#3 |
 Join Date: May 2013
Location: Beaver, PA
Posts: 516
|
Re: Hailbeck Chip Help
Steve, I've seen this before just like Dyno says the chip wasn't fully seated. You should be good to go now.
|
|
|
|
|
05-09-2015
|
#4 |
|
Join Date: Apr 2015
Location: Northwest AR
Posts: 95
|
Re: Hailbeck Chip Help
Well, I thought it was seated, would not go down any further. No worries, second times a charm I guess.
|
|
|
|
|
05-09-2015
|
#5 |
Join Date: Aug 2005
Location: Scottsdale, AZ
Posts: 2,452
|
Re: Hailbeck Chip Help
Really fixin this 1 up, great
|
|
|
|
|
05-09-2015
|
#6 |
|
Join Date: May 2007
Location: Chicagoland, IL
Posts: 9,710
|
Re: Hailbeck Chip Help
The blue and white clips on the side must snap into place. Then check the chip by turning ignition to ON, check to see that SES light flashes once.
__________________
[SIGPIC][/SIGPIC]Former Membership Chairman Former ZR-1 Registry - BOD 1972 Corvette 4speed base Coupe SOLD long time ago 1984 Corvette Z-51/4+3 SOLD 1992 Corvette ZR-1 Aqua/Gray #474 SOLD 1992 Corvette ZR-1 Black Rose/Cognac #458 2014 Honda VFR Interceptor DX |
|
|
|
 |
|
|
Hybrid Mode
